(800) 853-2651
SHOP NOW

Recent content by dpurvis

Yesterday's Tractor Forums
  1. D

    Compressor Problem

    Is there still pressure in the tank? If so drain it and then try, could be check valve letting pressure to top of piston. Then motor can't over come that pressure.
  2. D

    Tractor will only start and continue to run off a jumpstart

    sounds like your battery is dead and your generator/alternator/or regulator is bad.
  3. D

    Light switch on 4020

    full left off, one click right headlights and white rear light, next click right bright headlights and red tail light, next right click dim headlights inner headlights go out and red tail light,
  4. D

    Changing fluids

    every year on oil and filter, every two on coolant. hydraulics can go longer, i just watch to see for moisture. my 4010 is same senario as yours, haven't changed hydraulic fluid for three years and it looks as good as the day i filled it after last change.
  5. D

    806 steering

    he has had tractor for 5yrs. he says the sender was unhooked when he got it home, so he hooked it up and the light has always come on when clutch is fully pressed, up an inch and it goes out. but the tractor has worked flawless till now. thanks owen for responding.
  6. D

    806 steering

    delta red, anybody
  7. D

    806 steering

    son has 806. has steering at idle but is hard and makes screeching noise. as you raise rpm it gets worse, at 1900 rpm cannot move wheel. can drive forward or backward has brakes, three point works. front loader works, torque works with no slip. what should we look for? has sat for a month, last...
  8. D

    2004 F350 Gas Engine 6.8L Exhaust Studs Breaking

    just to add a note. the 2011 super duty has a 6.2 standard. abig upgrade from the 5.4, but the 6.8 v10 is still an option along with the 6.7 power stroke.
  9. D

    2004 F350 Gas Engine 6.8L Exhaust Studs Breaking

    you will need to pull the front wheel and inner fender, not a hard job. then remove the exaust pipe flange nuts and the manifold nuts that are still there. some may break as you try to remove them. then the best way is to get a extractor set which will have left hand drill bits and easy outs...
  10. D

    1/8NPT drill bit size?

    5/16 drill size.
  11. D

    Radiator overflow part 2, with pictures

    just get a good size balloon and zip tie it over the radiator filler. if its getting combustion gas in the cooling system when you start it it will blow it up. do this all the time at ford dealer on fuel injector rails to test injectors. iwould want the coolant level lower first though.
  12. D

    AM Radio Reception

    and its very probable that you will never cure the problem. this is very common for am and will never be real quiet. am is a line of sight signal and anything will mess with it.
  13. D

    First Bushhog - pic

    had an uncle that cut hay with bushhog for many years. had the side covered exept in rear center to leave a windrow. would break the stems and dry much like a mower conditioner. used in any hay, worked really good with alfalfa.
  14. D

    That's not good

    when it started running rough the gasket was already gone running one more round wouldn"t matter unless it got very hot, same fix either way.
  15. D

    Toyota sales

    mike m just to set it straight you have that backwards. all mazda pickups are ford rangers. there are really no mazda pickups.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top