-
D
Snow rig finally ready
You guys are in the deep sh'' ah snow all those big blowers and front loaders, heck where I live we may get 18- 20 inches on a bad dump most times it's 6-12, my little MF TO35 gas with 6 ft rear blade and chains digs out what I need and I spend some good will time pushing the snow for the...- Dr Ice
- Post #22
- Forum: Tractor & Farm Talk
-
D
Strictly Cosmetic
The spec on the diameter is 3 3/8th" which is just about the size of the tractormeter diameter, and it's in the rpm range needed for lower rpm work, this just may be the ticket without spending a lot of $$$, thanks JL Mac- Dr Ice
- Post #9
- Forum: Massey-Harris & Massey Ferguson
-
D
Strictly Cosmetic
I'm tired at looking into the gaping tractormeter hole on my Massey TO35, the meter was long gone by the time I acquired the tractor, it has 1 wire alt', electronic ignition, and oil press' coolant temp, voltmeter, I installed one of those cheap digital lcd "tach" but would like to fill that...- Dr Ice
- Thread
- Replies: 8
- Forum: Massey-Harris & Massey Ferguson
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy