-
DDrAllis replied to the thread ca Allis 1st and fourth gear.The shift lever doesn't stroke fully into 1st gear ?? and it does fully stroke into 4th gear but jumps out on it's own ?? On a coast or...
-
DDrAllis replied to the thread Allis chalmers 175 transmission/hydraulic reservoir.You need an owners manual. There are THREE drain plugs. One directly down from the seat is the transmission/differential and takes about...
-
DDrAllis replied to the thread Hydraulic Pump On A WD45 Engine.Anytime you find a plate on the carburetor side (left side) of the engine, the block has been frozen and cracked lengthwise. I've seen...
-
DDrAllis replied to the thread WD45 3 point hitch conversion diagram?.What are your intended uses for this hitch?? Category #1 size ?? Are you going to pull a mounted 3-bottom plow with it?? or much...
-
DDrAllis replied to the thread Smokey '73 Allis-Chalmers 200.Changing the static timing a couple of degrees more advanced might improve things....maybe.....and maybe not. But, I will guarantee if...
-
DDrAllis replied to the thread Smokey '73 Allis-Chalmers 200.What you consider a possible problem might be somewhat normal for a 50 year old engine that has a lot of hours on it. Especially a...
-
DDrAllis replied to the thread WD45 3 point hitch conversion diagram?.I've always used the snap-coupler latches on the lift arms when building a 3-pt hitch. It increases the height of the hitch when done...
-
DDrAllis replied to the thread Allis-Chalmers CA Rear Drive.I interpreted his post to say he just relined the hand clutch. But maybe not..................
-
DDrAllis replied to the thread Allis-Chalmers CA Rear Drive.Adjust the hand levers clearance. You need some free-play in the lever.
-
DDrAllis replied to the thread Hydraulic Pump On A WD45 Engine.The early D-17's had a gear driven/governor driven power steering pump, yes. It was 8 GPM and 1600 psi max. They had issues with the...
-
DDrAllis replied to the thread Hydraulic Pump On A WD45 Engine.Never ever seen one like that. I imagine the timing gears, after enough loader use, don't live long.
-
DDrAllis replied to the thread D14 Bendix/Ring gear questions.Flywheel is the same for 93 or 115 tooth ring gears.
-
DDrAllis replied to the thread 3rd gear for 615.I think 3rd gears are the same in all those models. But, I don't have access to a parts book to verify.
-
DDrAllis replied to the thread D14 Bendix/Ring gear questions.A 6 volt D-14 starter cannot be converted to a 12 volt 9 tooth Bendix. The starters are different. So, you either change to a 12 volt 9...
-
DDrAllis replied to the thread WD vs WD45.The short height cylinder head was used on all WC's, all WF's and up til the last year or so of the WD tractors. Starting in 1952 at a...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy