-
Ddrfarquad replied to the thread Case 530ck torque tube leak.Well against my better judgment, I went ahead and used RTV on this lower part. Let it set up for an hour or so. Torqued everything down...
-
Ddrfarquad replied to the thread Case 530ck torque tube leak.It appears the gaskets are just too thick. They arent wrong, its just to much for these lower bolts to fit up properly.
-
Ddrfarquad replied to the thread Case 530ck torque tube leak.If i take out the 2 small rectangles and also the cork gasket that goes above this piece. My lower 5/8 bolts line up perfectly.
-
-
Ddrfarquad replied to the thread Case 530ck torque tube leak.All gaskets fit and appear to be in the correct spot. Im trying a few different things this morning. Hoping for good results.
-
Ddrfarquad replied to the thread Case 530ck torque tube leak.Some pictures from last night, no luck finishing still trying to get that lower portion that attaches to the axle back in.
-
-
Ddrfarquad replied to the thread Case 188D oil pan.I dont have the cast oil pan, and im stuck on the other side of the engine not where the pump lives.
-
DHey everyone, so after discussing options with Seali. About the torque tube leaking into crankcase. He suggested doing the oil pan...
-
-
Ddrfarquad replied to the thread New member.I live in NEPA, at the tip of the poconos. Where we have more rock than dirt.
-
Ddrfarquad replied to the thread New member.Thanks everyone, someone replied to my other post with what seems like correct info. I love a good forum and before joining this one...
-
-
DWelcome aboard. I'll echo what others have said that this is a goldmine of experience. This is the only social media i use and I've...
-
DWelcome to you
-
DThose are great machines!
-
Ddrfarquad replied to the thread Case 530ck torque tube leak.Yeah I've been digging around on the internet trying to source one. Tried mcmaster and what not with no luck. Ill give him a shout at...
-
DIt's most likely that the seal is not made anymore, but rather two seals of the same size will replace it, one facing in, one facing...
-
Ddrfarquad replied to the thread Case 530ck torque tube leak.This is what i was thinking, but I couldn't understand how a seal can block oil from both directions until I saw youre post. I didnt...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy