Recent content by Dsisk

  1. D

    NH 640 twine wrap problem

    I have a 640 twine baler and it'll wrap fine but when it gets towards the end to cut one of the arms hits the cutter and it stops it's almost like it's bent down, and if I pry it past it still doesn't swing the arms back. Any help would be appreciated thanks
  2. D

    Allis 190 won't run

    Ok I've replaced the coil and it ran great for about 10 minutes then started acting up again and died so I changed the points and condenser and still no fire what am I missing?
  3. D

    Allis 190 won't run

    Ok I've replaced the coil and it ran great for about 10 minutes then started acting up again and died so I changed the points and condenser and still no fire what am I missing?
  4. D

    Allis 190 won't run

    Ok I have an Allis Chalmers 190 gas that recently had the fuel pump go out so I put a universal electric fuel pump on it been running fine baled several acres of hay over the past two months. Now it started sputtering like it was running out of gas then it would clear up for a few minutes then...
  5. D

    Allis 190 coil

    How many volts should my meter show going into the coil ?
  6. D

    Allis 190 hydraulic problem

    I have a Allis Chalmers 190 and the three point and the remote hydraulics are really slow , and the steering is a little jerky . It is the same when cold or warmed up. Do I need to change the filter or is there something else
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top