(800) 853-2651
SHOP NOW

Recent content by ducks1

Yesterday's Tractor Forums
  1. D

    MM gtc lp

    It is a G on lp 4cyl with a 340 cubic inch motor I was told it was a 51 GTC standard. What does a G weigh than and how wide is the tractor?
  2. D

    9 bolt rims do they fit all models??

    Are the center holes still same size? what does it measure and is the bolt pattern still the same except for lining pin?
  3. D

    20,000 gvw trailer do you need CDL

    chev crew cab diesel and tandem dual 20,000 lb gvw with 2- 7000 lb tractors do I need CDL combination license??
  4. D

    Ceiling mtd heaters what size do I need 30x54 pole shed

    What size ceiling mtd heater would i need for a pole shed 30x54 10' walls. 6" thick insulation. What size wood stove also?
  5. D

    MM G rear rims??

    What other model tractor rear rims fit on a Minnie G std. 34"? Does a W9 farmall single step? Does any one have 1 or 2 good ones? In WI or sorrounding states? call 715-412-1969
  6. D

    Western unimount NO MOVEMENT

    Thanks for all the help. I just had to ground the small terminal on solenoid that comes from the controller that was not the hot side. I grounded it to the neg on battery. Works great.
  7. D

    IH 400 LP how many made?

    do you have one? How much is a running 400 lp worth with no fenders or draw bar, has weights and looks good. and good tires and rims?
  8. D

    dodge v-10 vs 454

    I can purchase a 96 dodge ext. cab v-10 4x4 5spd trans dually with 93k miles. Is there any issues with these motors, and do they compare to a 454 from the 90-95 years for torque and hp? Is this the truck i would want for hauling around tractors or go with different one i want to spend under...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top