(800) 853-2651
SHOP NOW

Recent content by Ed H.-OH

Yesterday's Tractor Forums
  1. E

    3-point lift arms will not go down TO 35

    Hello......Try moving the small control around, it may help.......Ed
  2. E

    TO-35 No Lift

    Hello, Try moving the short control around and see if it helps, I bumped mine and the hitch stopped working , moved it back and it was fine.......Ed
  3. E

    Rear link arms castellated nut question!

    Hello JD. I have had my to35 for like 40 yrs, . I fixed that stud aprox, 20 yrs. ago and don't remember for sure, mine was tapered, and as long as it is tight there's little room for leakage, as i fixed mine as soon as it started leaking from loosening up, and it didn;t egg shape.....today i...
  4. E

    Rear link arms castellated nut question!

    Hello, That stud leaked on my to35. I run the front end in a ditch so the oil would run to the front of the gear case, pulled the pto shaft out and got on the inside nut with a breaker bar and socket through the pto hole ........took it out......put sealer on it and put it back in and tightened...
  5. E

    TO 35 lift raises slow

    Hello, Try moving the short control handle beside the main one up or down a little bit and see if it improves,,,,,,, Mine was acting up and i realized that i had bumped the small handle and moved it,,,put it back where it was and it was fine,,,,,,,,,,Ed
  6. E

    MF231S Perkins 903.27 oil pressure fluctuations

    Dan, come to think of it the one i worked on was a MF35, about the same year, There's a fair chance yours has the same problem,,,,,,,,good luck,,,,,,Ed
  7. E

    MF231S Perkins 903.27 oil pressure fluctuations

    Dan, Thanks for the reply, The one i worked on came in for serious low oil pressure when hot , I don,t recall how low as that was years ago.. I just wanted to give you a heads up if that was you,re problem, as it can be hard to troubleshoot ,,,good luck to you, and hello from Ohio......ED
  8. E

    MF231S Perkins 903.27 oil pressure fluctuations

    Dan, Hello, I worked on one of them with a similar problem, I dropped the oil pan and pressurized the oil system with a pump, and oil came gushing down from under the front gear cover, , pulled the front cover and found a bolt had come loose that holds a pressurized idler gear to the block...
  9. E

    MF204 (MF35 industrial) 3 point wont go down

    Hello, My to35 done that, Somone moved the short hitch control handle ,I moved it around a little and it dropped...hope this helps...ED
  10. E

    Yes more carb issues

    Hello, Put a new set of plugs in it and i bet it will start right up, You flooded it and the fuel we have today puts a coating on the plugs that shorts them out. Newer vehicles have high energy ignition and can burn it right off, the older stuff doesn't.....and you have to clean or replace the...
  11. E

    Question for Ed H.-OH about Sherman backhoe on T030

    Paul, Thank you for your reply, A lot of people don't bother....I have a 2000 ford, looked at it and you cannot connect to the top link as i described, Fords top link is weak and it doesn't have the long pin under it like the ferguson..sorry....Ed
  12. E

    Question for Ed H.-OH about Sherman backhoe on T030

    Paul, Hello, And thank you for your interest...My tractor is a to 35. And the backhoe is a 1954 sherman mod. B.. Made in Michigan by Wayne- Roy...They Patented and made the first backhoe...A piece of history. .construction went from pick and shovel to operators....If you look at the rear of the...
  13. E

    3PL Float modification?

    Hello from Ohio, I've been plowing snow with a back blade for 35 yrs...And every spring i had to rake the slag out of the yard back in the driveway.. Then i got a solution from Jerry MT. on this site. mount a length of 4 in. pipe across the cutting edge of the blade.It will slide right over...
  14. E

    Best Loader fit for a TO-35

    Thank you, I've done a lot of work with that old 35, IT'S 66 YRS. Old now and still running strong, Had it for 38 yrs..The liner packing went in it a few yrs. back so i overhauled it..I have a ford 2000 with a modern loader but i like working with the wagner......ED, And yes it has a pump on the...
  15. E

    Best Loader fit for a TO-35

    Make your 35 into a dirt digging machine,....Ed
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top