(800) 853-2651
SHOP NOW

Recent content by Ed NM

Yesterday's Tractor Forums
  1. E

    Suggestions on proper mask for painting with urethane

    I have a Hobby air unit with 40 ft. of hose in the paint booth probably not a professional unit but has worked well for me as I do not do that much painting. For small outside jobs and very small in shop jobs I have used 3M and Gerson masks. My Nason and Axalta paint supplier sell them. They say...
  2. E

    McCormick 10-20

    Thanks for your help. Will take it apart tomorrow.
  3. E

    McCormick 10-20

    Working on a friends McCormick Deering 10-20 tractor. Need information on where to set the float in the carb and where to get parts for the carb. Thanks for any hints and information.
  4. E

    Plow knee knocker

    Pictures of one
  5. E

    Plow knee knocker

    Here are a couple of pictures of one
  6. E

    air supply masks

    Good question. I started painting in the 70's and used Dupont paints. then it was mostly Duco, Dulux, and Lucite. I started using Centari with the hardners 792 & 793. I was told to use a respirator with the cartridges for these. You were to change the cartridges out when you smelled paint. When...
  7. E

    repair cracked engine block

    I have had Chapman welding in IL. repair a number of heads for me with no problems. They heat the head in a gas stove/ furnace until cherry red. The crack shows up as a dark line. With a torch they work the metal out around the crack and weld it back with a cast rod. They slowly turn the heat...
  8. E

    Question for Jim

    Where are you located. Looking in my Farm Collector Show Director I do not see any shows listed in New Mexico. Just wondered how much antique tractor activity there was. Thanks
  9. E

    F225 Disk Plow- Anyone have one?

    I plowed about an acre last fall with a 400 series 3 bottom disc plow. Seemed it pulled easer than my 3-14 # 55 plow.
  10. E

    Hvlp paint gun

    I have one I bought from lowes for $99.00 complete with regulator. Used once did not like it. $50.00 plus shipping. Ed 513 889 7777
  11. E

    Knee knocker

    Here is a picture of one on a 53 G that I am thinking of selling the tractor.
  12. E

    2030 batteries draining overnight

    I had a 2440 that did the same thing. Problem was the alternator and or external regulator. Changed to a one wire alternator.
  13. E

    rubber hub fan conversion

    I have a 36 B which the fan on the rubber hub worked its way towards the radiator. I drilled a hole in the center of the shaft (front) threaded it and tapped it. I put a 1/4 bolt with a large fender washer on it. The washer is a large diameter and has kept the fan in place for years. You cant...
  14. E

    Torque tube / Electric over hyd. brakes

    I have had two trailers with electric over hyd disc brakes. Never had a problem. I change the fluid and hoses every 2-3 years. I think the torque is a good option. At 15000 you probably do not need one, but would not hurt. I have one but sometimes haul over 24000#.
  15. E

    Which HVLP gun to buy...

    I have used a Binks # 7 for over 25 years. I have tried 3 different cheaper HVLP guns none did as good a job as the Binks. I recently bought a DeVilbiss FLG-4 from T.P. tools with 3 tips and a air adjusting valve for $185. I have used it for primer and a few small jobs with good results I think...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top