-
E
JD 111 mower belt
Thanks for the suggestions. I have 2 belts, the problem is with the long belt to the engine. It is a John Deere M82460 CPT. It looks to be fairly new, however it has jumped the sheave a number of times. The last time it jumped off I really had it tight, a lot tighter than I usually would. Is...- egbinor
- Post #1
- Forum: Garden Tractors
-
E
sizing tire chains
I have 3 sets of tire chains that were never used and would like to know what size tire they will fit. They were for cars from the 80's. They measure 11 in wide & 69 in long, 13X69in and 13X75inches. Thanks in advance for any help. EGBinOR -
E
JD 111 mower belt
I have JD 111 11HP mower with a 36in mower deck with a single blade. Serial # M8803820 H8010. This thing wasn't running when it was given to me. After a valve job it's running great but keeps throwing the drive belt. When the deck is up the belt is running level with both sheaves but when...- egbinor
- Thread
- Replies: 3
- Forum: Garden Tractors
-
E
Battery charger
I had this charger for around 40 years and it finally gave up. Diodes & rectifiers are beyond my grade.. I don't know anyone around here that works on these so looking at buying a new one. Used mostly on 6 volt tractor s and hvy duty stuff. I've heard bad stories about the late chargers with... -
E
Crescent wrench
I have one of the little channel lock pliers you show here. It was my dads but these days it doesn't do the things it did when dad carried it... I'm the oldest of 11 siblings and don't think it's an exaggeration to say that he pulled a dozen teeth with it.. I tried it with my son when he was... -
E
add light to pumphouse
???? was my attempt, in a nice way to say that the press switch had nothing to do with my post. The reason the contacts were burned was because the pump was short cycling due to the leak in the line and was able to do that for quite a long time until the pipe blew apart and the pump couldn't... -
E
add light to pumphouse
I have a well that's supplying water to two rentals next door to me. The tank and press switch are in my shop and the only time I hear the pump running is when I'm in the shop and it seems like I'm not in the shop as often as the time goes by. The pump has gotten water logged a few times without... -
E
putting mounting bolts in concrete
Been gone for 20 years but our truck shop floor had 4 of what you're talking about. We used them for various things. If you really had a need there wasn't much else that would work. The thread was different than anything Ive seen before. A very course thread that was very easy to unscrew. Had... -
E
sharpening drill bits
Is there a drill bit sharpener that really works?? In my golden years I seem to have lost the touch. Used to be 4 out of 5 was an average. Now it seems to be 1 out of 5?? -
E
What is it?
What is it? I've got a dozen of these hanging on a nail and can't remember what their for??
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy