(800) 853-2651
SHOP NOW

Recent content by ejb17

Yesterday's Tractor Forums
  1. E

    JD 51 Plow Parts

    Looking for both side wheel grease caps, X246A on the furrow wheel and JD 2570A on the open clutch side. Also, how does the furrow wheel come off? After I took off the broken X246A cap, the bearing sleeve came out about 1/2 inch and then stopped? What am I missing? Thanks in advance
  2. E

    U302 on the 4th.

    Happy Fourth of July to all of us in this Great U.S.A. Finished up all the things the U302 needed during the "lockdown". As I was going through all the small repairs , fixing leaks, putting in a thermostat, fixing all the gauges, etc... I found out that it would not hold oil pressure when warm...
  3. E

    U302 Fuel Gauge ohm Range

    I tried a "modern" 240 empty to 33 full and it is a no go. Doesn't seem to be the correct range for the stock gauge. Looked for a 300 empty sender and google came up empty.
  4. E

    U302 Fuel Gauge ohm Range

    I am guessing you mean 0 ohm empty - 30 ohm full? Seems to be what a lot of pre-1964 vehicles used.
  5. E

    U302 Fuel Gauge ohm Range

    I need a new fuel level sender for the tank. It has fallen apart but the gauge does test fine. Does anyone know what ohm range sending unit I will need to match the gauge?
  6. E

    u302 owners

    NAPA 2222
  7. E

    U302 Tach and others needed

    Looking for an early U302 tachometer. Mine make a lot of noise and bounces around in circles. Was this tach used anywhere else? Also need the plate that is under the "rate" and "cycle" levers that the decal sticks to. Any help appreciated.
  8. E

    U302 Question

    What is the purpose on the U302 for the small bolt on plate on the bottom of the tranny case?
  9. E

    Tractor info

    So I will take a stab at helping and maybe Chris in CT can chime in. The unstyled L has pedal brackets on the frame that were unique for the unstyled L. Also radiator mounts and the rear engine mounts were unique. If I remember correctly some of these mounts also had casting numbers on them...
  10. E

    U302 Battery Cover

    Alan K, please put me on the list for one cover and set of j-bolts. You can send me an email as I see yours is not linked. Thanks Eric
  11. E

    U302 Battery Cover

    Does anyone out there make or have a battery cover for a U302 with the 3ET Battery?
  12. E

    283A-4 Questions

    Near Buffalo NY
  13. E

    283A-4 Questions

    Recently acquired a 1949 UTS. It came with a spare engine that was part of the deal. Also came with 2 extra Cyl. jugs #10A149. Tractor runs great now that the carb is clean. Question is , is the engine or extra jugs have any value or would any one need those. Just don't see the point of the...
  14. E

    UTS Parts

    I am in Buffalo NY. Fastenal may be an option.
  15. E

    UTS Parts

    Looking at a 1949 UTS. Could use new fenders and the front axle is bent. Looking for leads to where to find MM parts as I am new to the MM world. Runs real nice and looks pretty straight except for the fenders and front axle. How the axle got bent and the Sheetmetal stayed straight is beyond me...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top