(800) 853-2651
SHOP NOW

Recent content by Ellsworth

Yesterday's Tractor Forums
  1. gears

    Weld it, key it or both?

    So I'm getting the front pump drive setup on my 3400, adapting a later model 776a loader onto it. The 776 uses a chain coupler at the pump, the 730 (standard equipment for the 3400) uses a moreflex 4 bolt flange adapter. I ordered a chain coupler from SurpCent and a splined sleeve. Turned the...
  2. E

    140 siezed clutch

    Here is how we got the clutch loss.1 block the clutch pedal down. 2 engage the PTO. 3 put a BIG pipe wrench on PTO shaft. 4 hit the pipe wrench with with a sledge hammer. It worked for me. BTDT
  3. E

    fuel barrel capacity

    It will be around 90 Gallon.
  4. E

    Doubling up rear weights on a Super A

    Yes you can! I have a weight on the inside and 2 on the outside. They are on a 46 B with 11.2 tires. They fit fine .
  5. E

    11.2x36 tire

    I have a pair that size. Uniroyal Grip Master 4 ply 90% very light checking 45 angle lugs. I am in SWIN. $475.00. Cell 812 622 0000.
  6. E

    Tires

    I have a set of each 14.9 are top cut 80%. 15.5 are very sharp road worn. 50-60% Both are mounted on 9 bolt 14" pressed wheel and rims. I"m at Exit 12 I 64 IN. Cell 812 622 0000
  7. E

    Tires Wanted

    I have a pair of both. 15.5 are road worn 75% 14.9 are top cut 85-90%. They are Maxi-MAX Like Armstrong. I am in SW IN.
  8. E

    farmall

    On the OE spring wire 3 to 5 coils together. That makes a stronger/shorter spring. Also back out the stop bolt.
  9. E

    Hay Rack Backing

    Have someone stand on the back of the load in the middle. Get wagon straight watch the person on the back and turn very little to keep the person going straight back. Most turn the front wheels to much to soon.
  10. E

    M W add ons for the Super M

    Also PTO Shift handle, Oil less air breath, 9 bolt hubs that bolted to the 4 wheel weight holes,and a strap with ball bearing to help slid rear wheel in and out.
  11. E

    Super A oil pump

    You will lose 5 PSI for each washer you take out. BTDT The new spring is not enough to give good oil pressure. There was a reason they were there! LET
  12. E

    Cliff S Tires

    I have a pair of 14.9 top cut,and 15.5 not cut but sharp road ware both are Armstrong/ Maxi Trac. I am in SW IN. Lowell
  13. E

    Which state produces the best pullers?

    They were pulling in Jefferson and Pike counties Illinois as early as 1945and46.
  14. E

    Tractor sales numbers

    Theses # are from external_link Ford N 830,000 Fordson 755,000 Farmall H&SH 420,000 M&SM 307,000 JD B 300,000 A 300,000 4020 168,000
  15. E

    It's pulling well, how do I get more traction?(video)

    13.9X36 might be a better size than 15.5x38. They fit a 12" rim. I was killing my Super H with 13.6x38 changed to 13.9X36 and it will spin them just as it runs out of power and rears.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top