(800) 853-2651
SHOP NOW

Recent content by EM Iowa

Yesterday's Tractor Forums
  1. E

    Burnt-smta

    I'm interested in your SM block. Can I have your contact info?
  2. E

    Looking for a 400/450 block

    Yes I would be interested that block. I assume it has no cracks or leaked anti-freeze like my current one did. Can have your email or your phone number to contact you?
  3. E

    SM Block in a 400

    If I remove everything off my 400 engine (crank, cam, governor, head, etc.) and assemble it on a SM block will I have any problems? MY 400 has the 4 1/8 pistons, will they fit into the SM Block?
  4. E

    1946 Farmall B Tractor

    Did you teach in Red Oak Iowa Mr. Meade?
  5. E

    Looking for a 400/450 block

    Does anybody have a 400/450 block they would want to sell. My FFA project is on hold until I find good block. It could be bare block or an entire engine. I'm in SW Iowa. I appreciate any help.
  6. E

    How much would it cost?

    Thanks guys, I think I may start looking for a new engine.
  7. E

    How much would it cost?

    I need to have my Farmall 400 block rebored and have repair sleeves placed in two cylinders. Would anybody have an idea how much this will cost? I live in SW Iowa, are there any reputable machine shops near me? Would it be cheaper to find a 400 engine for sale?
  8. E

    What to do! Anti-freze in oil on 400

    How much would it cost to have this done?
  9. E

    What to do! Anti-freze in oil on 400

    I began working on the 400 today. When I pulled the pan off I noticed antifreeze coming from between the sleeve and the block on the 3rd cylinder. Since they"re dry sleeves, does this mean I need to begin looking for a new block? Also, I checked the clearance on the current .002 over rod...
  10. E

    400 differential rust

    Are you about finished rebuilding those magnetos Kirk? I haven't heard from you since I dropped them off. I'm not in a hurry, I just don't want to forget about them.
  11. E

    My new decal is peeling off, what adhesive should I use?

    Thanks!
  12. E

    New addition to our tractor family

    I really like the looks of the wide-front on it!
  13. E

    My new decal is peeling off, what adhesive should I use?

    A new decal on the rear of my F-20 doesn't like to stay on in one corner, is there something specifically made to glue decals, or can I use super glue or rubber cement. I don't know what the decal is made out of, but I bought it from Rice Equipment.
  14. E

    F-20 Runs Rough

    Check to see if you have a steady stream of fuel going to your carb (use the drain feature on the carb), and if you do have a steady stream then it may be a distributor problem. Has the valve lash been set?
  15. E

    What to do if engine exhaust has some black smoke

    There is some black in the exhaust of my F-20 while idling and putting around. It's not a lot, but could it foul the plugs and make the engine not run well? Which screw controls this ( one on top of carb or near the bottom)? I'm pretty sure it goes away when under a load, so maybe this is how it...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top