(800) 853-2651
SHOP NOW

Recent content by Emiel

Yesterday's Tractor Forums
  1. E

    Dexta hydraulics don't lift

    Are your inlet strainer and exhaust filter clean? Did you do a pressure test? Maybe an o ring is not seated well and you lose pressure. Unload valve may be acting up. Many causes possible. Was it able to lift loads before you replaced the cam follower? Recently had to replace a dexta...
  2. E

    Fordson major backhoe engine swap/renovation

    I would Not Switch the injection Pumps. Fitting is different as is the timing. Youp end up with two faulty engines instead of one good and one bad engine
  3. E

    Fordson Major Diesel

    From a certain moment on, fuel lift pump design changed on these tractors. Old model is with glass bowl, new model is quite different. You might need another style lift pump for this engine.
  4. E

    5000 main drive pto shaft.

    Shaft just slides out. No red to remove transmission cover.
  5. E

    1955 Fordson Major Diesel Mystery Engine Part

    Would be my guess too. Fuel lift pump cam follower.
  6. E

    Dry air filter

    Should have an oil bath filter. No dey filter for them back then.
  7. E

    Ford 6610 oil pressure sender replacement

    In digital dash you need the three wire one, because it measures pressure which is shown on the dash. The single wire type will only show on or off in a light. You can not onvert a single wire switch to a three wire sender.
  8. E

    Thursday Truck 2/1

    Never look in the mirrors in such cases, I’m told. Can’t remember 😂
  9. E

    Friday Tractor 27/12

    The first 3 have tip coulters to cut the land. The last one disc coulters. Typical config for Holland at least.
  10. E

    Tuesday Truck 17/12

    Cargos are a smaller class, at least over here. The new large ford trucks made in turkey can be seen any now and then on the motorways here.
  11. E

    Tuesday Truck 17/12

    Nice truck. Same cab as Some Renaults but with cummins engine and roadranger gearbox. Some were assembled in Amsterdam I’m told. Would be a nice truck with a beaver tail to take the tractors to a show.
  12. E

    Major 1953

    Time to show some progress
  13. E

    Monday Tractor 11/11

    This must be a foreign copy of a Fordson tractor 😜
  14. E

    Fordson major

    Agriline in uk usually stocks both the old and the new style pump. Had an old style from them 2yrs ago. It was a really good unit, only required a washer to be able to tighten the oil pick up tube properly. The valve can be copied in a lathe with a bit of time and skill. Usually only freshing...
  15. E

    TW15 transmission knock

    Hi, not an expert myself but it sounds like a dual power problem. The cotter pin is there to keep a weep hole from plugging up with dirt. If a crankcase or transmission seal leaks it is there to let the oil out instead of lubing the clutch.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top