(800) 853-2651
SHOP NOW

Recent content by ErnieD

Yesterday's Tractor Forums
  1. E

    4 cylinder 172 diesel injection pump issues

    DieselTech is your expert; on this forum.
  2. E

    Ford 871 Oil leak

    Looks to me the o ring seal to hydraulic manifold has given up. Drain the hydraulic sump and remove manifold. Square O rings.
  3. E

    Flywheel Timming Marks

    Yeah I know, I turned the engine over real slow with wrench. This was a few years ago, Will try again for a look see, that rig needs to come in the shop anyway.
  4. E

    Ford NAA Oil Pressure Fix

    I have never had oil fix low oil pressure. Easy enough to roll new bearings in. I have always regretted taking a shortcut through the woods.
  5. E

    Flywheel Timming Marks

    I have a 172 with no marks on the flywheel.
  6. E

    I need help on Next Tractor advice

    Ford County 4WD Ford 801 w/Elenco 4WD
  7. E

    Rear main

    I did it on a 871, there is a kit to help extract the rope seal. I broke the seal extractor after I got it started. Ended using a punch and short wooden dowels to chase the bits out. Use neoprene half seals as a replacement. The side seals are a pain, use the fel pro kit.. The nails went in not...
  8. E

    Two Push Rods Out

    old gas will cause intake valves to varnish and stick
  9. E

    Jubilee Differential- 3 shocks!

    If it was mine; I would pull the pto shaft and manually clean the sump. BTDT.
  10. E

    Jubilee Differential- 3 shocks!

    pull the pto shaft out the back and check. how much did you add?
  11. E

    Row crop leveling box

    Heat red hot (think rose bud torch) and squeeze the top shut (spacer at bolt hole). If it is wrong, can you make it more wrong?
  12. E

    Firewood math problem

    volume of the log length x PI x r squared all in inches
  13. E

    I screwed up and I need advice

    Wrap threaded jet portion with teflon tape. Be careful to keep tape only on the threads. The yellow natural gas tape is thicker and a little easier to control.
  14. E

    Oil plug

    no narcotic like success
  15. E

    Knock

    Bad advice. If a spin on oil filter, are you using one with an anti drain back valve? cut an old one open, should be a rubber disk inside.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top