(800) 853-2651
SHOP NOW

Recent content by EX 450 Owner

Yesterday's Tractor Forums
  1. E

    OT 1953 Chevrolet powerglide engine

    I think the original poster is referring to the fact that in 1953 Chevrolet had 2 engine options. The manual transmission models had the older style 216 cid inline 6 cylinder, while the automatic or “power glide” models had a 235.5 cid engine with a full pressurized oil system.
  2. E

    Lincoln welder

    I don't known about the newer ones but; back in the early 1960’s when I bought my 225 amp Lincoln tombstone unit, the 180 Amp did not have a fan while the 225 amp model had a 240 volt impedance protected fan unit.
  3. E

    OT: Wiring on grand kids power wheels!!!

    There are 2 different wiring schemes here the one on the left switches the batteries in series or parallel, and the wring diagram on the right switches the Motors in series or parallel to provide the high/low function. The resistor connected to the throttle switch is a Dynamic Braking (DB)...
  4. E

    Picture(s) for Today

    The first crop of Soybeans I was ever around here in eastern Nebraska was a crop my uncle planted in about 1954.I ran the seed through a fanning mill and used a scoop shovel to mix in a black powder they call an inoculate while my uncle drilled the beans in. The following summer the local...
  5. E

    home built PS update

    That C454 number looks like a casting number you need to find out what the part number on that valve it could be any number of types of control valve depending on the spool installed in the valve body casting. Usually the flow valve used when a common pump is used to supply both the power...
  6. E

    Godspeed to Stormin' Norman

    A General who truly believed that you lead from out in front of the troops, not from somewhere way behind them. RIP Stormin Norman, It saddens me to think how few leaders like you are left in our Military.
  7. E

    OT/ Help - Plumbing prob!

    Flush the stool that is working ok and watch the pattern of how the water enters the rim of the bowl from the tank setting up a swirl that causes the rising water to “break the trap”. Now check the one that is not flushing correctly if you are not getting good flow from the rim holes and a...
  8. E

    Load bearing wall weight

    Use your internet browser to find LSB light steel beam. I have never used it but my SIL just used to replace a bearing wall. He went to a local lumber yard that was listed as one of 2 in our area that carried LSB and they gave him some software to calculate the size of beam he needed. When he...
  9. E

    Reminder of why I hate horses and never milked cows!!!

    LLA if you would have carefully read JD Sellers first post you would have seen that he said he [u:afd9c33d69][i:afd9c33d69][b:afd9c33d69]made[/b:afd9c33d69][/i:afd9c33d69][/u:afd9c33d69] 1 set of shoes. Don't know where you are from, but around here all of our horses tend to have 4 feet, which...
  10. E

    Postal money order versus bank money order

    Do you write personal checks on your bank account? It seems to me that every personal check I have ever seen contains the account number and the bank routing number at the bottom of the check, I know that mine do. Every time you write a personal check you are making that information...
  11. E

    O.T. subaru small engines

    My generator also has a Subaru Robin, I've had it for about 8years, since it is rarely used every time I run it I shut off the fuel valve and let it run until it runs the carburetor dry. Then every 4 months or so I drain the gas and use it something else and put in new gas in the generator...
  12. E

    Keep A Spare furnace ignitor

    Try this place for igniters and other HVAC and plumbing parts. http://www.pexsupply.com/Hot-Surface-Ignitors-1615000 The igniters are rated for voltage and amperage along with time to get to operating temperature. Along with that the physical size shape size and mounting, and the...
  13. E

    Anyone had catarac surgery?

    I had both eyes done about 7 years ago; it went great and really improved the vision especially when driving and the oncoming head lights caused “night blindness”. After about 5 years the regular implant lenses begin to cloud so they cleaned them with a Laser, painless and took less than 10...
  14. E

    John T - RMS voltmeter and new Inverter Microwave

    True RMS reading voltmeters measure the waveform a great number of times during each ½ cycle and then perform a mathematical calculation on the collective readings to find the RMS value while the cheaper meters assume the waveform is a perfect sinewave and the RMS value is always 0.707 times the...
  15. E

    converting 3 point post hole digger.

    The conversion can be done but it needs to be engineered correctly. I suggest you go to the following link and look at, the hydraulic, the hydraulic technical help section, and the mechanical couplings they have. http://www.surpluscenter.com/hydraulic.asp The hydraulic motor of your...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top