(800) 853-2651
SHOP NOW

Recent content by farmallm46

  1. F

    Big Exhaust manifold Massey Harris

    This message is a reply to an archived post by jean claude marleau on May 13, 2015 at 08:15:21. The original subject was "Big Exhaust manifold Massey Harris". Do you still have it for sale???
  2. F

    Farmall M Ignition timing for stock class puller

    okay this is 25degrees at the crankshaft correct? all my measurements where done from there
  3. F

    Farmall m Firecraters ignition timing

    All my measurements are from the crankshaft
  4. F

    Farmall m Firecraters ignition timing

    im measuring the 22degrees at the crankshaft
  5. F

    Farmall m Firecraters ignition timing

    maybe im wrong but I don't believe it is physically stopped at 22degreess because isn't the standard m suppose to have something like 35degrees total advance not sure the exact number but know it is higher. so I know I can get more timing advance out of it then 22degrees but that's not my question.
  6. F

    Farmall M Ignition timing for stock class puller

    and I know that you don't run wide open 1750rpms down the track and the rpms drop under a pull. But if you have your total advance set at 22degress at 1750rpm your timing advance at 1200rpm for example under a pull will be 15degrees(for example). And if you have total advance set at 28degrees...
  7. F

    Farmall M Ignition timing for stock class puller

    Makes sense, so you are saying I should run less timing advance during a hard pull?
  8. F

    Farmall m Firecraters ignition timing

    We have a 46 M with 4" firecraters that we use to compete in the antique stock class pulls in our area. I have searched to try and find the answer to my question but cant find what im looking for. Everyone says to time the motor to 22 degrees at wide open throttle with firecraters but what rpm...
  9. F

    Farmall M Ignition timing for stock class puller

    We have a 46 M with 4" firecraters that we use to compete in the antique stock class pulls in our area. I have searched to try and find the answer to my question but cant find what im looking for. Everyone says to time the motor to 22 degrees at wide open throttle with firecraters but what rpm...
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top