(800) 853-2651
SHOP NOW

Recent content by farmallphred

Yesterday's Tractor Forums
  1. F

    1206 steering hydraulic lines

    I stand corrected, those are oil cooler lines, not power steering lines. Thanks all.
  2. F

    1206 steering hydraulic lines

    I need to replace the two hydraulic lines that run from left side near the left battery then up and over the air cleaner and then to the top of the radiator left side. When I do so do I need to bleed the air out of the system somehow?
  3. F

    Super M Brakes

    I had tossed the old pads prior to realizing the issue. I am having shims fabricated. Everything else has been cleaned up, painted and is ready for reassembly. Thanks everyone for the advise.
  4. F

    Super M Brakes

    Alternately could the 2 plates actuator contact surfaces be milled down by .050?
  5. F

    Super M Brakes

    Would the sheet metal shim be the full perimeter of the housing or just intermittent?
  6. F

    Super M Brakes

    I am reassembling my Super M disc brakes. When I stack the disc pads and actuators assembled with balls the last pad in actually sits higher than the housing. New parts include pads, balls and springs. The balls are the standard 7/8" balls, the pads are the rivet style at 33/64" thick per...
  7. F

    Stalling Farmall Super C

    Both tractors 6 volt positive ground. There seems to be two varieties of coils, one with plastic casing, one with metal. Plastic casing variety around $25, metal casing $60. I've gone through 2 of the metal casing variety, both failed in short order. I've not tried the plastic casing variety...
  8. F

    Stalling Farmall Super C

    That's what I was thinking as well from the wiring diagrams I could find. The + terminal on the coil should go to the distributer. However the M was wired reverse of that and that is how I hooked up the C and it ran great. Either way I likely need a new coil. Any suggestions on a source? I've...
  9. F

    Stalling Farmall Super C

    I finally had some time to work on the Super C. I'm doing some grading work with a belly blade. I ran the tractor until the stalling issue started and then checked fuel flow removing the plug at the bottom of the carb. I got 1 pint in 2:30 minutes, so fuel flow was not the issue. I put my hand...
  10. F

    Stalling Farmall Super C

    sed red MN - Is there a link or search topic to the other post you reference? I'm not finding it.
  11. F

    Stalling Farmall Super C

    Most are suggesting gas flow issue. Do Super Cs have vapor lock issues? I am going to pull the sediment bowl with the in tank strainer to check for clogs before running the next time. If after that I continue to experience the problem I will, when tractor starts to sputter release the gas tank...
  12. F

    Stalling Farmall Super C

    I've replaced the condenser at least once, with the points, plugs, wires and coil.
  13. F

    Stalling Farmall Super C

    Rustred - When you say the coil is hot is that like hot if I keep my fingers on this they will blister or I can keep my fingers on this but feeling really hot?
  14. F

    Stalling Farmall Super C

    Rustred - I've pulled the drain plug on the carb and get good flow but not sure exactly what good flow should look like. Do you know if this is like a quart a minute or how much should be expected? I have not felt the coil after the stalls but will the next time I run the tractor. What would...
  15. F

    Stalling Farmall Super C

    Good suggestion. A lot of my use is dusty work which I suppose could clog the vent. I just put on one of the tall gas tank caps that are designed to prevent gas from staining the top of the tank. I guess when the tractor starts acting up I could release the cap and see if it starts running better.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top