(800) 853-2651
SHOP NOW

Recent content by Farmer7

Yesterday's Tractor Forums
  1. F

    Christmas greetings from South Wales

    What a terrific thing to do. Hope I get this right: Nadolig Llawen a Blwyddyn Newydd Dda
  2. F

    massey ferguson mf 34a info

    Point taken. Like jbarnes I was curious as to when my 20 industrial was built plus being a newbie to tractors. You bring up a very good point as the two (industrial and agricultural) may not coincide concerning years, part numbers, etc., Is there a number for AGCO answers that a newbie like me...
  3. F

    massey ferguson mf 34a info

    I have a 1969 MF 20 Industrial backhoe and from what I've learned they are very similar to the MF 135. Given that plus not being able to find much info on the 20 Ind., I went to Vintage Massey Ferguson 135.com and found this info. My serial number coincided with it being a 1969 model year build...
  4. F

    massey 135

    I have a MF 20 industrial and am told that it is basically a MF 135. I changed the plugs in my 3 cyl. gas Perkins without removing anything except plug wires. The gas tank front bolt is difficult to remove so I left it alone. You might want to have a small shop vac nearby before removing the...
  5. F

    135 spark plugs

    You're right as I went to an auto parts store to get plugs for our tractor and they brought out the NGK plugs and I was a little apprehensive as the manual said Champion UJ8. Well they worked just fine and I was a happy camper. Was amazed though to see so many different plugs on your list but...
  6. F

    135 spark plugs

    I have the same motor in my MF 20 industrial and the manual calls for Champion UJ-8 (14mm) Gap 0.025 inch. Hope this helps
  7. F

    MF 135 Upgrade update

    Got my MF 20 Industrial Service manual and original operator's manual on SOMeTHINGbay. The service manual is a reprint for around $88. Don't expect too much with the photos as they have been reproduced many times over. It is better than nothing and has been a tremendous help. The original...
  8. F

    Tachometer on a MF 20 Industrial

    Going out to the Farm today and will check it out. Many Thanks PTFarmer. Have a great day
  9. F

    135 gas tractor runs for a while then dies

    I had a similar problem with my MF 20 Industrial which is basically a MF135. Would sputter and backfire then it would run fine for a few minutes then start running bad again. Sounded like an electrical problem so I replaced the points, condenser, rotor, coil, plugs, even the key switch. When...
  10. F

    Tachometer on a MF 20 Industrial

    Hi, recently purchased this tractor/backhoe and the Tachometer does not work. The main reason, that I know of so far, is that there is no cable. New to tractors so not sure just where the other end of the tachometer cable goes. I didn't see anything near the distributor and haven't checked the...
  11. F

    mf 135 3cylgas perkens

    Hi, I have a MF 20 industrial with 3 cylinder Perkins and I've been told that it is basically the same as a MF 135. Given that, the points should be set at 0.021 and the timing should be 26 degrees before top dead center with the engine running at 2225 - 2275 rpm. Hope this helps
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top