-
F
another fordson hydraulic issue like the rest.
Just got it. It was the back pressure valve under the oil exhaust filter. It had grit and the plunger was stuck. Freed it up and worked in and out with wd and pb blaster. I am very happy!- FarmerMike1
- Post #1
- Forum: Fordson
-
F
another fordson hydraulic issue like the rest.
found a graphic pictorial view. I see there is a back pressure valve in the oil exhaust tube at the oil exhaust filter. obviously I need to check why I have no back pressure from this valve. good talk guys lets see what happens. I guess I will keep every one posted.- FarmerMike1
- Post #1
- Forum: Fordson
-
F
Fordson Major Diesel problems
as far as your sims pump its not one of those "ones that takes oil" it is what that call a helix port or plunger type pump in line. I don't know what year you have, but the early ones had pneumatic guvnor.- FarmerMike1
- Post #1
- Forum: Fordson
-
F
another fordson hydraulic issue like the rest.
under the (snail) looking thing there was a pluger with a spring and a ball bearing. when you remove it the inside bore beyond that is a threaded hole which to me I thought should have something to back pressure to unseat the ball to send the fluid over to the cylinder. when I pulled the ball...- FarmerMike1
- Post #1
- Forum: Fordson
-
F
1962 b275 pto sliding clutch for front shaft
wow that's expensive for a sliding clutch. I'm used to eaton transmissions no so expensive. thanks for the replay- FarmerMike1
- Post #1
- Forum: Tool Talk
-
F
another fordson hydraulic issue like the rest.
was told its a 1962 power major. 4 cylinder diesel. I got it and the arms were stuck in the up positon even with pto not engaged. checked oil and it was milked with water. pulled top drained water and oil, and cleaned entire case front to back. cleaned top out and cylinder really good. relief...- FarmerMike1
- Thread
- Replies: 7
- Forum: Fordson
-
F
1962 b275 pto sliding clutch for front shaft
good morning guys! was wondering if any one here has an avenue for getting a sliding clutch for the pto shaft in a b275. I search the parts and am not finding it. took me a while to find the shaft but did find that. had a problem where the snap rings on the bearings broke allowing the shaft to...- FarmerMike1
- Thread
- Replies: 2
- Forum: Tool Talk
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy