-
Fflameeater replied to the thread Ford 8n Hydraulics.LOL I was responding to Hokie when you posted this. I will try this when the storms around here ease off a bit. Out of curiosity, if the...
-
Fflameeater replied to the thread Ford 8n Hydraulics.Thanks for that. I am having a hard time sourcing this. I am looking for a male unf to female npt correct? Does it matter if it is...
-
Fflameeater replied to the thread Ford 8n Hydraulics.Would this gauge work? Just screw it into the port at the bottom of the pan, and see what it reads...
-
Fflameeater replied to the thread Ford 8n Hydraulics.Never mind on the port, I found it.
-
Fflameeater replied to the thread Ford 8n Hydraulics.I honestly have no idea where that port is located, nor do I have a gauge. Can you give me more info, perhaps a picture of the port, and...
-
Fflameeater replied to the thread Ford 8n Hydraulics.On the dipstick it is at the top of the full mark. I would assume the dipstick is correct, unless it has been swapped out for some...
-
Fflameeater replied to the thread Ford 8n Hydraulics.Oh, and yes I did have the PTO engaged and lift controls were at the top. It was running a bit below half throttle at this time. Also...
-
FJust wanted to get someone with more knowledge's input before I spend money or tear anything apart for rebuild. My 8n SHOULD if in...
-
Fflameeater replied to the thread Stripped threads in idle jet.Man, this actually helped me to get it climbing hills even with the cheap knock offs. Oddly enough my dad bought a carb for the tractor...
-
Fflameeater replied to the thread Stripped threads in idle jet.The one I am trying to repair looks almost exactly like this one, aside from the name on it. Mine has no identifying marks at all that I...
-
-
Fflameeater replied to the thread Stripped threads in idle jet.The carb itself is kind of black, looks like it used to have red paint on it. For sure it is the MS TSX line, not zenith. As for the...
-
Fflameeater replied to the thread Stripped threads in idle jet.Oh, yea I suppose I could have been a little more specific. Its a 48 8n. I think it is the tsx 33 (it has no markings or tags). If it is...
-
FHello all, been a while since I have been around here. A while back I tried to strip my carb (I can't tell if it is an authentic MS, or...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy