-
F
Found on shop floor (pic)
Got two of them sitting in front of me, axle nut retainer clips, the two inch outside diameter is the same as the ones I have # 8N4187, they don't have the tension tightness as the old ones, think I'll try zip tie trick- flatlandfool
- Post #1
- Forum: Ford 9N, 2N & 8N
-
F
Oil Canister Top Bolt Gasket
had the same problem on some of my tractors, after replacing gaskets from over tightening decided a piece of soft plastic would work. made some gaskets up from pop bottle plastic, then moved over to quart oil cans (plastic) the flat sides were easier to cut into washers, now have a supply to use...- flatlandfool
- Post #1
- Forum: Ford 9N, 2N & 8N
-
F
Spindle Bushings
On the bushings that I did on the 2N recently, the bushing didn"t require it, they slipped in tight but the spindle fit fine, think I read posts that stated that the new replacement bushings were made without the need of honing. Could be wrong too!- flatlandfool
- Post #1
- Forum: Ford 9N, 2N & 8N
-
F
Do they sell the right kind of bolts on this site ???
Are you getting a new replacement Radiator? Generally the replacement ones come with the keyslot that use the carriage bolt set up, and the bolts are pretty common at ace hardware etc.- flatlandfool
- Post #1
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy