(800) 853-2651
SHOP NOW

Recent content by flic50

Yesterday's Tractor Forums
  1. F

    Super A Clutch

    Just an update: I had the engine on the chain fall for easy dissasembly (good thing, I did it a bunch of times). I would put it together and just bump the starter to check the clutch. I tried it with the clutch disk in both ways and it didn"t fix the problem. I went to check my manuals for...
  2. F

    Super A Clutch

    I took apart the tractor to replace the Pilot Bushing, and have had an issue upon reaseembly. Now the clutch will not dissengage. I checked the throwout bearing and readjusted the clutch pedal. I checked to make sure the driveshaft was not catching in the new pilot bushing. All looks good...
  3. F

    International I4 Tire Question

    I got 7.00x20 tires on the front (heavy front end). They are in decent shape at the moment, just mismatched. I am thinking of putting ag tires on, only since I would be using it around the farm. Do you have the 10" rims as well?
  4. F

    International I4 Tire Question

    Hello; I finally got the old tires off the 24" split rims. They are 12.00 x 24 industrial tires. I measured the width of the rims to be 10" (outside to outside). I am just wondering what sizes others have put on their tractors (I have seen some pictures of ag tires on these tims). I just...
  5. F

    Anything not to common in your collection

    I got a 1948 International I-4 with the heavy front end that came out of a local rail yard. Needs a few things but runs ok.
  6. F

    W4 QUESTIONS

    You can also check the serial number on the block too, should be on the right side upper front. If I remeber correctly, my I4's block is stamped that it is an "I" on the block too. If it wasn't tarped and covered with snow I would go check. The engine number may not be the same as what was on...
  7. F

    Super A Clutch/Transmision Noise

    I have been watching with interest recently with the Super A tranny questions. My Super A makes a chirping/grinding noise as I let the clutch out, but stops once the clutch is all the way out. It does this in all gears. I replaced the clutch around 7 years ago, all new and had the flywheel...
  8. F

    international i-4

    I have an I-4 as well, mine has the heavy duty front end, but regular breaks. I entered it in a local tractor pull (the thing is a porker, weighed in at 4660 with only me on it) and it did decent, I kept up with my friends oliver 77 diesal in 4500, 5000, and 5500 lb class. A lot of the parts...
  9. F

    Farmall Super A Steering Bearings

    Thank you for all the help. I was able to find the parts I needed from the suggestions, and now I have nice tight steering. I am going to make a note of that kit though, I have two other A's with bad steering. Thanks again. - Mike
  10. F

    Farmall Super A Steering Bearings

    Hello; I have a 1949 Super A with loose steering. I took it apart, and upon inspection found that the bearing on top of the Steering Worm Wheel Shaft is bad. I also figured i would replace the lower one too while I had it apart. Does anyone know where to get replacements? Thank you - Mike
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top