-
F
Question about location of bolt tension adjusting bolt
Hi, I am putting on a new water pump on my vintage Ford 601 Workmaster tractor. I had to take everything off the front and now that I installed the new waterpump, I have to put the fan belt back on. I cut the old one off when I took everything apart a few months back because my plans were to...- Ford601Workmaster
- Thread
- Replies: 3
- Forum: Restoration Processes
-
F
Need advice on obscure Ford 601 part
Yeah the washers are like that depicted in that FIAT link you have up for New Holland tractors. Small lock washers that fit on the small bolts, behind the bolt heads and sitting on top of the outside of the fan blade. I looked at them again today and two are broken. I suppose I will have to...- Ford601Workmaster
- Post #1
- Forum: Restoration Processes
-
F
Need advice on obscure Ford 601 part
No... One lock washer behind each bolt. Not being used as spacers.- Ford601Workmaster
- Post #1
- Forum: Restoration Processes
-
F
Need advice on obscure Ford 601 part
Hello, This is my first post and I need some advice. I have a Ford 601 Workmaster and am doing a waterpump change on it. I took the fan off the water pump to remove the bad water pump. Underneath the four screws that held the fan blade, there were four small washers underneath each bolt...- Ford601Workmaster
- Thread
- Replies: 10
- Forum: Restoration Processes
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy