Recent content by FrankM

  1. F

    Replacing TO20 starter

    besides a few choice words being said I did get it mounted
  2. F

    Replacing TO20 starter

    tractor was converted to 12 volt, starter went bad, was told to get 12 volt Wilson rebuilt starter and cannot get it mounted.I have removed distributor,coil to no avail.and bendix looks different. Overall length starter is about 1/4longer than original.looking for suggestions
  3. F

    Receiver hitch snow plow

    check out Hitch N Plow on youtube where you use your own cat 1 rear blade to move snow .attaches to lower pins and tilts or lifts blade using a winch attached to top link
  4. F

    Enlarging hole on side of house

    Just cut a plug to fit in old hole use its pilot hole to keep it centered, may need scrap wood inside if acessible to keep plug from falling out while drilling
  5. F

    40 utility touch a matic problem

    I know my pump is good and with cold weather in Iowa haven?t worked on it
  6. F

    40 utility touch a matic problem

    Single t-o-m arms would bounce under load on arms now no lift at all, when it first happened I took the rockshaft section off and found bypass valve was stuck,now if you run engine arms come right up with no load but will not lift implements moving quadrant lever does nothing. Any ideas or...
  7. F

    Well some times you win!!!! Lucky tractor purchase.

    Good for you! Once in a while a person gets lucky, how far from Iowa City are you?
  8. F

    TO-20

    does it make a difference it has been changed to 12 volt. I'm going to work on tractor tomorrow. I have not seen it yet.
  9. F

    TO-20

    It has been a lot of years since I was around a TO-20. Owner can not get it started .Does this tractor have a solenoid or just the gearshift operated switch has ignition switch with start position and solenoid. which is right. according to serial number it is a 1949.
  10. F

    OT: Where do you live?

    Washington County, City of Washington,Iowa Our city celebrated our 175th last year with over 175 tractors in a parade.
  11. F

    Funny Xmas eve story, use discretion, I will do my best...

    Several years ago I delivered the evening paper. A lady had a lap dog that would bark at anything, so one day she is outside with dog in her arms,I went to hand the paper to her,the dog jumps out of her arms, hits the ground,jumps up and nails me on the end of my private area, I look down...
  12. F

    Merry Christmas

    Merry Christmas from southeast Iowa! Just want to say thank you for all the help I have received from this site this year and looking forward to 2015.
  13. F

    Latest/Best Dumpster Dive

    laptop computers, tv's tools, bolts, hats, 12 volt lawn sprayer, several flashlights. I have worked for solid waste haulers the last 6 years so you never know what you will find. The best haul was a 2 cu. yd.dumpster that was loaded with a lot of brand new bolts even had 4 old carbs that I...
  14. F

    1945 B

    Good deal! I wasn't sure what all you had done to it, didn't think about nozzle not being seated right. Merry Christmas!
  15. F

    1945 B

    When I worked on my DLTX34 I followed Roberts Carb video and used a tap that just fit the nozzle and put about 1/4"of threads took a long bolt a couple of washers and a nut and pulled it out no heat at all. just clean out rust the best you can.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top