(800) 853-2651
SHOP NOW

Recent content by Frarck

Yesterday's Tractor Forums
  1. F

    2N starter

    Do you mean that it is not spinning fast enough?? It is spinning as fast as it can and us running fine
  2. F

    2N starter

    I use a new 6 v bat and a pair of heavy jumper cables. That should be enough seems like.
  3. F

    2N starter

    Does anyone have a picture of the 2N starter in both engaged and disengaged positions? The bendix just does not look correct. when running on the bench should the drive gear be all the way toward the motor and when not running should both front and rear units be close together or nearly...
  4. F

    2N starter

    I load tested the battery (6 V}. 100 amp load for 15 seconds and it stayed up very well. I have heard that this type of bendix should not be spun out on the bench and I have not done that. Got the Replacement starter from Steiner in Michigan.At this point I probably should contact them since...
  5. F

    2N starter

    Is it ok to test the starter on the bench for proper operation on my 2N. Starter is new but appears to be locked up after sitting for several weeks without starting. Battery tests good..Loosened the mounting bolts on the starter and something clicked at the bendix end of the starter. This was...
  6. F

    2N hot starting

    Problem solved, very weak spark, changed out the wiring and that did the trick,, appreciate the suggestions and help.
  7. F

    2N hot starting

    Thank you all for the suggestions to an old man with fingers getting sort of slow on the mechanical stuff anymore but it is still fun despite the slowness.
  8. F

    2N hot starting

    No have not, another thing needs doing, thank you
  9. F

    2N hot starting

    Ordered a new switch since this machine has sat outside for quite some time, thank you for the suggestion
  10. F

    2N hot starting

    My 2N starts great when cold but does not want to start when warmed up. Good spark. Is it likely to be carb settings or??? Thanks for your consideration.
  11. F

    Stuck 2n

    stuck starter thanks for all the replies
  12. F

    Stuck 2n

    The problem indeed was bad starter. Forgot about Murphys Law Anyway going to get a new starter. The old one that has been there since 1945 bit the dust.
  13. F

    Stuck 2n

    I fail to understand what is going on and where to look next Tractor was running fine. brought it into the shop and changed the oil and oil filter, now the engine is stuck. Can anything other than stuck pistons be the reason. Cannot turn the engine over with one rear wheel jacked up and the...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top