-
F
1910 won't start
I didn't have time to check the fuel system yet but I did check the glow plugs. Each glow plug measured around 3-5 ohms to ground with a cheap meter. At rest the battery was slightly over 12 volts. With key in heat position the voltage at the rail was around 7.8 volts and at the battery was... -
F
1910 won't start
I just got my brother in law's 1910 back together after a new clutch. It sat for about three years in a heated shop. Turns over good but doesn't fire and nothing from the stack. My diesel experience is limited so looking for tips on where to go next. I know I need to check fuel and glow... -
F
Convert 1910 dual stage clutch to single stage?
They show a single stage for the 1900 so I thought it could be converted. I figured it held both the shafts. Guess not. -
F
Convert 1910 dual stage clutch to single stage?
Because the clutch disk will likely get stuck to the pressure plate again and cause all kinds of problems. I can't find intermediate plates for it and no one will regrind them. Looks like I will have to buy a whole new clutch assembly. -
F
Convert 1910 dual stage clutch to single stage?
What all needs replaced to convert a dual stage clutch setup to a single stage? Can I reuse the flywheel? Any good sources for parts for this machine? -
F
How to remove Ford 1910 flywheel?
I downloaded the service manual. I let out a big groan when I saw that the final adjustment of the fingers need done thought the hole in the bell housing. It's completely covered with the loader bracket. One more thing to remove. -
F
How to remove Ford 1910 flywheel?
Thanks got a nice brass hammer for the job! -
F
How to remove Ford 1910 flywheel?
I need to remove the flywheel from a Ford 1910 with a dual stage clutch to have it resurfaced. I have removed the large center nut but the flywheel is very tight on the crankshaft. Any tips on how to remove it? -
F
OBD Code scanner recommendation so far
If you're a serious mechanic you'll need a bidirectional unit. No two ways about it. If you just want codes then a sub $200 unit will do. -
F
How does 1910 PTO clutch work?
Ok thanks! I've never had a dual stage apart but that's the only way I could envision it working. -
F
How does 1910 PTO clutch work?
I've tried adjusting it. I should have put that in my original post. -
F
How does 1910 PTO clutch work?
Do you have a link to what drawing you are looking at? Everything I see isn't very clear. I've heard of the double clutch setup but I don't understand how that works. Is there a double shaft? Like a shaft inside a shaft? -
F
How does 1910 PTO clutch work?
I'm repairing a 1910 that you cannot engage the PTO without grinding. The gears are destroyed. I have new gears and now I have to figure out why the PTO won't engage without grinding. The clutch works fine to stop the tractor and change gears. Just the PTO has this problem. I'll be...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy