-
F
2012 4025 Blowing White Smoke at PTO RPM's
Our 2012 Mahindra 4025 with 340'ish hours wont maintain PTO RPMs and blows white smoke. It starts and idles perfectly, but wont run at higher RPMs. We changed the fuel filter, but that didn't help. Can anyone recommend what we should we try next? Thank you. -
F
65 Ford 3000 Lift Won't Work
Used the bleeding procedure y'all taught me. Ran the tractor for 30 minutes shutting it off every 1.5-2 minutes looking for bubbles. Saw bubbles every time. Ran it another 30 minutes, shutting it off every 10 minutes looking for bubbles. Again saw them every time. Thought that I was doing... -
F
65 Ford 3000 Lift Won't Work
We ran it for about 30 minutes and saw bubbles each time the engine shut off. It got dark on us so we plan to try again tomorrow. I'm confused regarding the new fluid though. The brand new fluid seems milky like the the fluid it replaced? -
F
65 Ford 3000 Lift Won't Work
Thank you. Hope to get to it today or tomorrow. -
F
65 Ford 3000 Lift Won't Work
I see. Thank you. How in the world does air get into that system? -
F
65 Ford 3000 Lift Won't Work
Thanks! So if there are visible air bubbles in the tubing when the engine is off, continue the process until none can be seen? Air in that system will prevent the lift from functioning? -
F
65 Ford 3000 Lift Won't Work
That helps a lot. I'll give it a try. Thank you! -
F
65 Ford 3000 Lift Won't Work
I have the I&T manual but can't find any pump "bleeding" or "burping" procedure. I wasn't able to find it on YouTube either. From the comments it seems like a reasonable first step, I'm just unsure as to how to do it. -
F
65 Ford 3000 Lift Won't Work
Thank you. I'll check YouTube again to see if I can find some help with bleeding the system. -
F
65 Ford 3000 Lift Won't Work
I don’t have remotes, but there is a lever below the seat to the left of the 3pt hitch lever on the side of the lid that looks like it could be the “remote handle” you are referring to. With no remotes, should it be up or down? Thank you. -
F
65 Ford 3000 Lift Won't Work
We’ve had the tractor about 4 years. Hasn’t run in about 3 years. I truly can’t remember if the lift worked or not when we quit using it, but my wife said she remembers it not working. Is there some place I can learn how to bleed the air? Thanks. -
F
65 Ford 3000 Lift Won't Work
Thank you. So the I&T manual will outline the procedure for burping the pump? -
F
65 Ford 3000 Lift Won't Work
Thanks. I’m not sure how to bleed at the pump? Or to use compressed air as you suggested?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy