-
F
IH 430 baler cam pick up tooth controller
Does anyone have any experience replacing this plate? I started baling and the pick up assembly stopped dead in it tracks. Thought it was the clutch but after investigating that was good. Was able to get the plate back and the hub off to look inside the cam follower and the metal had worn...- Furjam6
- Thread
- Replies: 4
- Forum: Tractor & Farm Talk
-
F
IH 430 baler with 10 thrower
Need help with thrower. I bought this baler mid summer and did a lot of work and got it up and going and baked some with it. Then it sat for 2 months. Busted it out and had issues with the thrower. The bales would get to it and then jam the rollers and the pulley would just spin on the drive...- Furjam6
- Thread
- Replies: 1
- Forum: Implement Alley
-
F
IH 430 baler tube for pto
Could someone give me some advice or point me in the right direction on where to find the tube on the pto for this baler. Original snapped at the weld and have looked all over at local tractor and farm stores and have not had luck on finding the 1 1/8"x 1" rectangular tube any help would be...- Furjam6
- Thread
- Replies: 7
- Forum: Implement Alley
-
F
IH 430 baler
You nailed it on the head. The baler had been sitting for 2 or 3 years the cradle was alittle sticky and wasn t moving all the way back up to press the plunger stop rod. Got it up and running today. Thank you for your time to post.- Furjam6
- Post #7
- Forum: Implement Alley
-
F
IH 430 baler
Needles are going up. The knife on the plunger makes it about halfway before jamming.- Furjam6
- Post #3
- Forum: Implement Alley
-
F
IH 430 baler
I m just starting out baling my own hay and picked up an IH 430 baler. Have had some issues but worked through them and hooked up to run and snapped the shear bolt. It seems to be the plunger getting jammed. But it gets stuck when the arm is about to turn over going forward and backwards. Just...- Furjam6
- Thread
- Replies: 6
- Forum: Implement Alley
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy