(800) 853-2651
SHOP NOW

Recent content by fuseblower

Yesterday's Tractor Forums
  1. F

    Ford 2000 Question

    Thank you very much sir. :)
  2. F

    Ford 2000 Question

    I have a Lucknow Snowblower attached to the 3 point hitch and am having a problem levelling it because of lack of adjustment. The blower has not been modified and my lift arms look original. Also my tire size is original.
  3. F

    Ford 2000 Question

    I am trying to determine how low the arms are supposed to go down. Mine are almost at the end of the adjustment (bottom of the shaft) any more and the shaft will pull out. It seems like the arms on the axle end need to go lower to give me some adjustment but that is not possible.
  4. F

    Ford 2000 Question

    Doesc anyone know the approx distance between the ground and the lift rear arm when the 3 point hitch is all the way down.?? Tractor is a Ford 2000 3 cyl 1972 model.
  5. F

    Actual wire plug wires

    Yes I have been readding up on various types. I don't need to worry about electronics on my 1972 Ford 2000 :) Thanks
  6. F

    Actual wire plug wires

    OK Thank You . I will call the number. I hope they have actual wire not carbon. :)
  7. F

    Actual wire plug wires

    That is good info. thanks. I will check it out,
  8. F

    Actual wire plug wires

    I just tried to order on line but they do not support canadian customers. The boxes open up for the USA only.
  9. F

    Actual wire plug wires

    I want to purchase replacement plug wires for my Ford 2000 3 cyl gas tractor. I do not like the carbon wires but would rather actual wires instead. Anyone know where I can purchase them? It would be nice to have the boots to fit the cyl head.
  10. F

    1972 Ford 2000 Carb replacement.

    Mine was leaking real bad. I replaced the gasket but the casing was distorted. I plan to try to polish both haves so they fit tight together. I could use a flat fine stone to do it by hand.
  11. F

    1972 Ford 2000 Carb replacement.

    I just saw your post. I have been away for a while. I bought a Zenith fron Steiner Tractor. But thank you very much. And Merry christmas.
  12. F

    Ford 2000 3 cyl no gas to plugs on start

    Thank You. I will try that sequence. :-)
  13. F

    Ford 2000 3 cyl no gas to plugs on start

    Thank you for that. I will try some variations using the choke. I am always nervous about flooding ,but this engine does not respond that way. I guess i need to learn more about updraft carbs :)
  14. F

    Ford 2000 3 cyl no gas to plugs on start

    Yes I used a plug but the gap waas not 1/4 inch. i must try that. Thanks :D
  15. F

    Ford 2000 3 cyl no gas to plugs on start

    I have replaced the wires, coil, distributor cap and rotot. The points looked OK so I just checked the gap. The spark looks strong using an external spark plug but i have ordered a spark plug adjustable gauge to be sure.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top