Recent content by G Archer

  1. G

    Single stage urethane

    Hi all, Im getting ready to paint my 58 Ford 641 Workmaster.I would like a recommendation on a single stage urethane paint that will not break the bank.Are there any manufacturers other than the top auto paint suppliers that sell a good urethane? Thanks for any help? Glenn
  2. G

    Fenders

    Hi all,I need to purchase a set of Ford fenders for my 641.Are the fenders sold on this site good quality? Thanks Glenn
  3. G

    MF 35 Repair manual

    Hi folks hope you can help.I downloaded and MF 35 service manual and it shows everything I need but the Z134 gas engine.It show all the diesels but nothing on the Continental z134 engine.Is there a good manual source out there that wont break the bank. Thanks,Glenn
  4. G

    Which model Ford tractor?

    It has 4 forward speeds
  5. G

    Which model Ford tractor?

    Hi everyone, I have a Ford tractor that I,m not sure which model it is.The serial # is on the left side of the engine and reads 9N205619.It has a front mounted distributer and a 4 speed transmission. Thanks for any help. Glenn
  6. G

    641 Firing

    Found the problem.Centrifigal weight support plate broke loose from the distributer shaft.Weight was striking the post in the dist grounding it out.Got to spot weld it back in place.Thanks for all the replies. Glenn
  7. G

    641 Firing

    Update. Installed new Standard brand cap,rotor, and condenser.Still no fire to the plugs when cranking the starter.Loosened the dist.and rotated base where rotor lined up with # 1 terminal on dist and it will crack blue spark on tester attached to # 1 spark plug.Turn starter over and no...
  8. G

    641 Firing

    Thanks for the replies.This is a restoration project.Engine caught fire from leaking fuel line and destroyed all wires and such.Installed new parts and the engine was running fine but stopped like the key was turned off and has not started since.Since I have good spark from coil I was leaning...
  9. G

    641 Firing

    Hi folks, I have a 641 that will not fire at the plugs.New points and condenser,coil, dist. cap, wires,and rotor.When I turn engine over I have a crisp blue spark from coil wire when I touch it to a ground.I can touch it to the coil post on the dist.cap and I get nothing.Do I have a bad cap or...
  10. G

    Hydraulic oil

    I have a Ford 601.Can I use aw 68 hydro oil in the hydraulic system. Thanks Glenn
  11. G

    Tractor paint

    What is a good paint for a tractor that will last and wont break the bank?I plan on getting to bare metal the using an epoxy primer. Thanks Glenn
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top