(800) 853-2651
SHOP NOW

Recent content by Gary730

Yesterday's Tractor Forums
  1. G

    Farmall Super-A transmission problem, please help

    Thanks Pete, This is the way I'm thinking I need to go. Can you email me, and maybe give me a phone number...I would like very much to be able to talk to you on the phone.
  2. G

    Farmall Super-A transmission problem, please help

    Thanks for all input, everything mentioned I have already tried. I replaced all bearings that were less than perfect. I don't know what else to do. I would disassemble it again if I knew what to look for. Any more input would surely be welcome. I have hundreds of dollars in bearings and seals...
  3. G

    Farmall Super-A transmission problem, please help

    . The transmission in my super-a has a noise like a worn out roller bearing on the end of the input shaft. I disassembled the transmission, replaced all four roller bearings, they all look bad so I thought I solved the problem. Oh no, after a total tractor re-build, including all new...
  4. G

    Super-A hydraulic Problem

    Eureka! It is fixed. I put it together for the 7th time, and now it works. Apparently the relief ball end of the unload piston had a odd shaped wear pattern due to 60 plus years of wear and tear. Apparently when re-installing the unload piston, it was never back in the original position...
  5. G

    Super-A hydraulic Problem

    Jim, in answer to your question, yes it doesn't unload regardless of where the piston stops in it's travel. I have it on my work bench, and I have the end plate off, anything you can suggest to help me figure this out is greatly appreciated
  6. G

    Super-A hydraulic Problem

    The screen had a minimal amount of contamination and the orifice was clear. Thanks, and can you think of anything else? Is it possible that the hydralic level being too full could create this problem?
  7. G

    Super-A hydraulic Problem

    Super-A Hydraulic Problem S/N322212 I re-sealed my leaking touch control unit, it worked fine, but had a small leak at a spool valve. I purchased a re-seal kit, cleaned everything, and put it together. All went well, I thought, and no leaks. But now it won"t un-load the hydraulic pump, the...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top