Recent content by gatorwade

  1. G

    gasket sealing

    What is the best way to seal a water pump gasket to prevent coolant leakage? How about sealing the governor gasket to prevent oil seepage?
  2. G

    9N Governor Overhaul?

    The I&T manual says remove flyball unit, shaft, and driven gear assembly from governor body after removing base screw. Couldn't find a base screw listed in the parts manual. I removed one little slotted 6-32 screw from the governor body assembly but nothing comes apart. What knowledge am I...
  3. G

    9N top end noise

    At last, back to the tractor bench. Want to check out the governor internals. It is off the tractor, but how do you take it apart?
  4. G

    9N top end noise

    Thanks for all the helpful comments and suggestions. I haven't picked up the wrenches in the tractor shed since I posted this. Busy in the seat of another 9N pulling a mower through the spring grasses in the orchard. I had to pull the governor to get the valve cover to clear the stud, so I will...
  5. G

    9N top end noise

    Recently purchased, but not running. Replaced fuel system and ign parts. Despite anemic starter she starts, idles and runs. No smoke or oily exhaust. O Boy sez I, but after running a while a taptaptaptap or tingthingting noise comes from the front upper end of engine. Pulled valve covers, all...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top