Recent content by gcg

  1. G

    Coolant leaks at hose connections

    True, maybe I'm too much of a perfectionist. I suppose after a restoration I expect too much. A couple of older folks told me these old tractors usually dripped something from day one and the paint wasn't perfect out of the factory, either. I guess that makes mine just like new! G
  2. G

    Coolant leaks at hose connections

    Get an occasional puddle on the floor from coolant leaks from hose connections (3 of 4 of them) on my 9N. New hoses, some double-clamped now. Freshly painted cast iron. Seems to happen when we have temp drops. Loosened radiator cap and that didn't help. Sometimes it'll go a month or two...
  3. G

    Paint scheme on 2N

    My '41 9N (a.k.a 'Puddles') was dark blue (well, half rust) when I bought it and I could find no dark grey underneath. I also wondered what the original color was. Eventually I found the grey inside the air cleaner and on a few other obscure places as I disassembled it. I figure maybe the...
  4. G

    9N Greasy lining and drum after Sure Seals Installed

    If you happen to still have that bearing pulling jig and could post a picture, that would be appreciated.
  5. G

    9N Greasy lining and drum after Sure Seals Installed

    ....and I believe replacing the outer seal means removal and replacement of that collar that has to be heated to red and slid over the axle. Ugh.
  6. G

    9N Greasy lining and drum after Sure Seals Installed

    When I restored my '41 9N last year I saw the brake linings were greasy. At that time I greased the bearings and installed Sure Seals, but did not replace the brakes. Instead, I cleaned up the old shoes, drum, etc with Brakleen hoping they would work 'good enough' and at re-assembly everything...
  7. G

    Oil only warm?

    Thanks to everyone for the advice and info!
  8. G

    Oil only warm?

    Yep, it is pushing air to the front - and as far as I can tell it is the original fan - I simply assumed this was just how they were set up - thoughts?
  9. G

    Oil only warm?

    thanks - I'll give that a shot. What really surprises me is the efficiency of this new radiator. The water going in is obviously extremely hot; by the time it gets into the lower radiator hose, it's just warm. Very large quantity of warm air blowing out the front as well. Now that the hood...
  10. G

    Oil only warm?

    Hi Bruce - yes, brand new thermostat that was tested before installing (also double-checked the direction it was installed).
  11. G

    Oil only warm?

    A little concerned about oil flow - I ran the '41 9N about a half hour yesterday, quite a bit of time at half throttle or so. It was about 38 degrees outside. I was showing 24 lbs of oil pressure on the new gauge and a couple drops came out of the governor as usual (I have more work to do...
  12. G

    Carb Dripping from Drain

    Thanks.....looks like I have plenty of things to try.
  13. G

    Carb Dripping from Drain

    The sediment bowl cutoff 'weeps' a little and I plan to replace it - but only a little. The gasket under the float valve seat is new. The needle seems to move OK - just sticks closed very slightly due to the rubber tip. I was able to tighten the valve seat 1/4 turn - could that have been the...
  14. G

    Carb Dripping from Drain

    Thanks....air cleaner was torn apart and cleaned when the carb was rebuilt so no dirt there....
  15. G

    Carb Dripping from Drain

    Having a problem with my carb. It is a TSX-33 on a 9N. The carb was rebuilt and I'm now trying it out. I'm getting excess gas in the chamber with the venturi and choke plate and it's coming out the 'weep' hole - I got a little when I ran it a week ago; now I collected what I estimate is about...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top