Recent content by gebell1301

  1. G

    Dexta upper lift arms

    Looking for a source for the upper lift arm tab lock washers used on the Dexta. I've exhausted the internet with no luck, so short of making them, I'm asking if anyone else might have a source.
  2. G

    Dexta Hydraulics

    Thanks, really appreciate the info! I was ready to purchase a new one. Merry Christmas! Gary
  3. G

    Dexta Hydraulics

    I'm restoring a 1960 dexta and discovered that the hydraulic ram connecting rod attachment hole is way larger than the attachment pin. The hole in the connecting rod doesn't appear to be worn or distorted. The pin which slides through the ram arm is in good shape. Is this designed this way or is...
  4. 8

    Thank you Dell

    My last question on this site a few month or so ago was answered by Dell about cold weather starting. He suggested putting a light bulb on the intake manifold, as did Royce and a couple others.. But it is Dells comparison to a small aircraft that sticks with me. Be cause I can honestly say when...
  5. H

    900 Case

    So I'm trying to get gearshift out of 900 case. Pictures of broken shift lever, then of both ends of pin going through shift lever, and the 2 little clips I took off that retains the pin in shift lever. Any help on this ??? TIA: Hemi
  6. 5

    Quick hitch scraper blade

    I am looking for a scraper blade for my 1953 super c. First of all were they made? Second, anyone know where I could find something like that? I want to use it to clear snow and scrape the lane. Thanks for any help
  7. Mac AR

    Seasonal Disconnect

    So this evening after yarding some hay, I pulled the old 300 in the shop and had the thought of disconnecting the pto. It makes a gawd awful racket when the pto isn't engaged. So under I went and now, I'm stumped. The book says pull the lever back. It won't go back but 1/2 an inch. Its in the...
  8. G

    Paint Code

    Looking for the orange paint code Alkota uses on their pressure washers. thanks!
  9. G

    Ford 7610 clutch issue?

    No not a cab tractor, Open Station, as stated clutch components are new/rebuilt and have been checked twice.
  10. G

    Ford 7610 clutch issue?

    Tractor is hard to shift into or out of gear. Tractor acts like the clutch is not fully disengaging however, the clutch was rebuilt (disc and pressure plate) and has been rechecked. Clutch appears not to be the problem, so I"m thinking possibly a sized pilot bearing. Tractor tries to creep...
  11. G

    7610 Flywheel

    When the clutch assembly was replaced the pilot bearing and the throw out bearing was replaced. Additionally the clutch input shaft was replaced. The disk was installed IAW the shop manual. The pressure plate was fully seated (none of the bolts are bottomed out nor are the dowel pins holding the...
  12. G

    7610 Flywheel

    Yea, it was on correct (unfortunately). The clutch didn"t slip, it just didn"t fully disengage. I"m trying to eliminate everything that could possibly cause the problem. I had the pressure plate and disk checked and the shop recommended looking at the flywheel. Said this is what happens if the...
  13. G

    7610 Flywheel

    Anyone know the specifications for the 13 inch flywheel on the 7610? While replacing the clutch assembly I had the flywheel resurfaced. Now the clutch doesn't fully release. Looks like the flywheel is the problem. Bottom line I need to know the minimum acceptable thickness for the flywheel. thanks!
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top