(800) 853-2651
SHOP NOW

Recent content by gene in la.

Yesterday's Tractor Forums
  1. G

    NO hydrolics

    I tried spinning the PTO shaft and the arms DID raise the up! That tells us the pump is working so we need to look somewhere else correct? But the PTO lever still won't move! Any other advice! And thanks so much for all the great advice every one is giving it's greatly appreciated!!! Gene
  2. G

    NO hydrolics

    PTO shaft turns freely by hand, not running motor
  3. G

    NO hydrolics

    The lever will not move back and forth stuck in forward position I believe; but the PTO shaft out back of tractor will spin freely!
  4. G

    NO hydrolics

    My question again is "took my TO20 to local Votech. shop to replace PTO shaft seal in rear but they couldn't remove the PTO shaft out rearend! So they split tractor to see why but saw no reason!!! Our thinking is shaft is bent; so it would not come out! But now after put back togather it will...
  5. G

    TO20 Can't remove pto shaft

    I took my TO20 to the local votech school to let the students get experience working on an old tractor! They loved the old tractor! Well they were going to replace the pto shaft rear seal but they couldn't get it out! So they split tractor to see why and didn't see any reason! Then when they...
  6. G

    Waterr in oil??????

    This is the second spring I have had water in oil! It ran fine all last year after changing oil and cleaning out the water and put Bars radiator stop leak in; but again this spring I have water in oil (a lot of water)? But no oil in radiator; (course I haven't ran it yet to see if any oil is in...
  7. G

    12 volt alternator

    I just converted my To20 to a 12 volt alternator! my question is; will it do any harm to let the tractor set outside and get the alternator wet till I can build a shed for the tractor? Thanks Gene
  8. G

    TO20 12volt conversion

    Well I decided to go ahead and buy the conversion kit; from 6 volts to 12 volts! But my question is; do I still use the voltage regulator, or will that be explained in the kit? Thanks Gene!
  9. G

    TO20 Dead generator

    No I have tried polarizing generator, but not sure I did it correctly, please explain again the correct way! I sparked from battery to generator terminal?
  10. G

    TO20 Dead generator

    I have aTO20 with a generator that's not putting out any voltage! Have replaced voltage regulator! Checked all wiring! My question is should I have the generator rebuild for $100 or get a conversion kit to 12 volts for $100!!! Any help will be appreciated!!! Thanks Gene in La.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top