(800) 853-2651
SHOP NOW

Recent content by gene_acres

Yesterday's Tractor Forums
  1. G

    D-14 Hydraulic pump broken cam follower

    Does any one know where I can get a new cam follower for my 3 point lift pump? What about the springs also probably weak. I have not disasssembled it yet. Afraid to until I ahve most parts to reassemble at the same time.
  2. G

    D 19 Hydraulic Woes (Long)

    Jeff I am not sure how old this is. I have a D-14 that stopped lifting a couple years ago. I finally pulled the pump on it. The cam follower is also broken. The plungers seem to be sticky. There is also a ridge on one side of the am. I am going to follow in your foot steps and the suggestions...
  3. G

    tranny pops out of 3 rd gear unless you hold it in.

    Going to do that this am. It has been this way for a couple years though!
  4. G

    tranny pops out of 3 rd gear unless you hold it in.

    I have a d-14 that the it pops out of 3rd gear when it unloads the tranny like going down hill. Does any one have an idea what could be wrong? Is this a shift fork? Is it adjustable? Gene
  5. G

    Hyrdraulic pump cam follower

    I have a d-14 with a broken cam follower on the lift pump. Does any one know where I can get a new one?
  6. G

    1957 D 14 Allis Chalmer broken 3 point pump

    I have a D14 that the 3 point stopped lifting a few years ago. Nice weather today here in Colorado I am bored as heck. I pulled the pump the roller bearing that is run by the cam is laying sidways broken I am guessing. Is there a place to buy these parts. There is no parts break down for that...
  7. G

    Allis Chalmer D-14 Smoking

    It has a cap on the exhaust pipe. I am in Colorado it has not rained here in a month. PS My wife had oil all over her face. So that probably eliminates the water thing.
  8. G

    Allis Chalmer D-14 Smoking

    OK did not think of that. But the only way it would be water is the head gasket and that would effect the compression right? It is very light could be white.
  9. G

    Allis Chalmer D-14 Smoking

    Ah If those are valve guids (seals) and it keeps smoking for a while it must mean they fell out (wore completely out) Correct. Usually valve guides just smoke on startup. It has been running great for 5 years.
  10. G

    Allis Chalmer D-14 Smoking

    Good eye 1957 I think. Gene
  11. G

    Allis Chalmer D-14 Smoking

    Yes PCV Valve I had it spelled right the first time and corrected it. What is Seafoam a trip to the Bahamas?
  12. G

    Allis Chalmer D-14 Smoking

    I started my 1950 D-14 on Saturday and it is blowing this constant light grey smoke. I checked the compression on all 4 cylinders and they are all around 130 psi Is there any kind of PVC valve on this old boy?
  13. T

    oliver 550 shift pattern

    could someone explain the shift pattern on a oliver 550.it has 3 foward gears and reverse but on the dash the shift pattern label has low and hi gears,does it have low and hi and how does it work?
  14. G

    D14 3 pt not raising

    Fluid was just a little low not much. I loosened the fitting going into the back plunger on the outside and ran lift there is no fluid coming out. Wouldn"t I see that oil leaking around there some where? SO must be pump or broken cam on lever. But arm to raise feels like there is resistance...
  15. G

    D14 3 pt not raising

    My D14 just quit raising the 2 point. Any ideas on what could casue that? Has Hyrdaulic fluid. Quit last year but was real low on Hyrdrualic fluid filling it up fixed it that time. Not helping this time.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top