(800) 853-2651
SHOP NOW

Recent content by Genos

Yesterday's Tractor Forums
  1. G

    Joe Young another 611-b question?

    Finally got gaskets from Case/IH and the gasket between Hi/Low box and trans. looks the same on both sides to me, in my I&T Book it says it has to be turned the correct way or it will leak between casematic and trans.? I'm thinking they now make that gasket so it can go either way, is this...
  2. G

    Everyone like to collect something.

    I am from Parke County In. with 32 covered bridges, and you all need to come & drive your tractors through them on our Covered Bridge Antique Power Annual Tractor Tour always the last W.E. Of June.
  3. G

    Case parts catalog R.I. 372 for 500b-600b tractors

    I need a big favor from someone, i have a Case Parts catalog # R.I. 372 with 12 pages missing, if someone has one and could scan these pages. and email them to me or put them on here & i can print them off, i would really appreciate it. the pages missing is the project i'm working on now...
  4. G

    Casematic oil leaks into trans. rear diff.?

    Sorry Guys it is a 611-b
  5. G

    O/T Coolant Loss

    I have a 2001 Buick LaSabre (3.8 litre emgine) and it looses about the amount from the hot to cold mark on plastic tank where you add coolant in 500 miles. can't see it on garage floor? no visible leaks, runs good. any ideas? Thanks Gene
  6. G

    Casematic oil leaks into trans. rear diff.?

    Have to add oil to casematic and drain excess amount out of rear end. have repaired rock shaft piston and it don't leak down. would new gasket between hi-low range gearbox and trans. stop this leak? anyone had this happen? i know would have to split tractor. Thanks Gene
  7. G

    611-b steering shaft bushings thanks

    No there 1 in. I.D. by 1 1/6 O.D. you are right about the other sizes being available. but not these. shaft is worn so I'm having a guy turn it to 7/8 and make 2 bushings to fit. Thanks Gene
  8. G

    611-b steering shaft bushings thanks

    Like i said, 1 in. I.D. and 1 1/16 O.D. like i said. it's odd to me too.
  9. G

    611-b steering shaft bushings thanks

    anyone got a source for these bushings? $71.00 each at dealer, ouch! need 2 of them . 1 in. I.D. by 1 1/16 O.D. local brg Hse says no too thin. I miss working where could get them made in machine shop. that 's the only thing i miss. they maybe need to be split longways to get them in without...
  10. G

    New to YT and to Case

    we have a 530H like yours i think, it has model 31 loader and backhoe. we don't have a serial # either, but found out on this site it's a 1960 or 1961 year. the power steering reservoir is where you said, reach under hood & loosen 1/2 bolt from center of cap to fill, there is a filter in there...
  11. G

    Pulling 611b steering wheel?

    Thanks Joe! i guess we were thinking the correct way to get the shaft out, now to get steering wheeel off, i have pulled quit a few steering wheels, but was not saving them on tractors i restored, but this is a working tractor. even pulled one on a J.D. B and when it came off the wheel, the...
  12. G

    Pulling 611b steering wheel?

    Trying to pull steering wheel on 611b row crop, has plastic covered wheel 1 wide spoke. is this shaft tapered, got nut off, anyone got one of these off without destroying steering wheel? i am trying to get the shaft out to replace both shaft bushings, looks like i will have to take the framework...
  13. G

    Case chrome sider

    My 611B has chrome on both sides of hood from dash to about middle of engine, still very good shape. friend has 530 with chrome also. gene
  14. G

    Safety Wire... where do I get it?

    They taught us how to safety wire in B-47 school 55 years ago, i still have a roll somewhere? it's very stiff stainless wire, not fun to do by hand. Not the same as Mechanics wire.
  15. G

    tightening rear rims on H or M

    Anyone know a way to tighten clamps on rear rims to keep rim as even as possible all the way around? seems like it pulls in all directions when using an impact. no rim is not bent. thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top