-
H
Omni MTK paint and coverage
I am painting an Oliver Hart Parr 18-28. I have painted these tractors before using PPG Delstar acrylic enamel with great results. That product is no longer available in my area and my supplier recommended the Omni MTK urethane over the MAE enamel. I used the MAE on a MM corn sheller and...- hunt
- Post #1
- Forum: Paint and Bodywork
-
E
R Model and Intro
Good day all. This is my first post on the site. I didn't see an introduction area, but since I have a John Deere, I figured why not here. I do have a question about the R though. The Crank that is on it seems to have work down where the flywheel goes on. I actually have a new flywheel...- Estes
- Post #1
- Forum: John Deere
-
J
Draft control rod
Does the draft control rod hole need to line up with the hole on draft disc?- Jaypat88
- Post #1
- Forum: Massey-Harris & Massey Ferguson
-
K
snow in SC
Light snow Sunday AM. Temp was 33. Snow did not stick to ground and road. Supposed to have rain today, then temps in the upper 20s at night starting Wednesday. I feel for you guys further north that have to get out and feed cows in the snow, especially if you have a tractor without a cab. I...- keh
- Post #1
- Forum: Tractor & Farm Talk
-
W
8N Generator Acting Erratically
My 8N Generator is suddenly acting erratically with my digital voltmeter reading jumping around showing voltages from 0 to 19 volts with the engine running. I do not see any wires loose on the generator and the regulator is hidden below the tool box so I cannot see it. The voltmeter just...- WayneMo
- Post #1
- Forum: Ford 9N, 2N & 8N
-
S
Ford 2000 gas , 1973, installing a new fuel pump
Hello, I'm going to install a new fuel pump, I have the alternator off, the alternator bracket to the water pump , also. Is it possible to remove and install the new pump without taking out the radiator? And, the pump is extremely close to the water pump housing above it, I hope you don't have...- Scissorman
- Post #1
- Forum: Restoration Processes
-
G
Bought Bolens Iseki Tractor & 7 Attachments....Value?
225 views and not one estimate? Someone has to have an idea. Thanks! -
G
Bought Bolens Iseki Tractor & 7 Attachments....Value?
Hello, I bought a Bolens Iseki tractor that has been garage kept, it has the tractor tires w/lots of tread, it needed a battery and some new cables but fired right up and seems to run strong with no leaks anywhere. It came with 7 attachments: 2 brush hogs, a blade, a towing attachment, an...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy