(800) 853-2651
SHOP NOW

Recent content by Ghosttrooper

Yesterday's Tractor Forums
  1. G

    Ford 3600 Popping out of gear

    Outstanding advice, Thank you. I did notice it happening more once I installed the gasket so the shifter going above the shift gates makes good sense. I'll measure and report. Thanks for the advice.
  2. G

    Ford 3600 Popping out of gear

  3. G

    Ford 3600 Popping out of gear

    I can back out of the barn, put it in gear and drive for an hour or two and it's fine. But somewhere along the way it comes out of gear. The shifter is loose and the tractor is still in gear. I can move the shifter anywhere and when I let out the clutch, it will continue moving forward. My...
  4. G

    Ford 3600 Popping out of gear

    Thank you. I got the entire shift cover with levers.
  5. G

    Ford 3600 Popping out of gear

    Hi all, I have a Ford 3600 and for the past two years the shift levers pop out of gear as I put it away in the barn so the neutral is ineffective. My clutch will still stop it but I cannot reengage the gears. I've been popping the shifter plate off and re-aligning it so I can put it in reverse...
  6. G

    Ford 3600 Radiator issue

    Quick update, Looks like the Axle pin and bushing were not the only issues. The mounting plate for my bucket loader seems to have sheered the mounting bolts off into the frame as well. This causes the entire front end to shift down over an inch which is causing the radiator hose to sheer off...
  7. G

    Ford 3600 Radiator issue

    Thanks so much Ultradog. I actually soldered it the last time this happened and it worked for a day until the arm crushed it again. This is the third time I have taken it apart to fix it. Hopefully the bushings and pin will fix the issue. I'm getting tired of taking this thing apart. :D
  8. G

    Ford 3600 Radiator issue

    Great suggestion, I'll give that a try. With the weeds growing quickly now I need to get back in the saddle quick. I'm assuming it is ok to weld the pipe back onto the radiator. Thanks again.
  9. G

    Ford 3600 Radiator issue

    I recently replaced the radiator on my Ford 3600 because my old one rusted. I am running into an issue where the front wheel arm is rising up and sheering/crushing the bottom radiator tube that the radiator hose is attached to. Nothing else has changed from the old radiator except the new...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top