(800) 853-2651
SHOP NOW

Recent content by glock40

  1. G

    What is that noise?

    Well it's time for an update and I have progress to report. I will also have to tell on myself a bit, but it pays to be humbled once in a while. To refresh, I have rewired entire tractor, new plugs and plug wires also, and new Pertronix electronic ignition. Also new starter and new carburetor...
  2. G

    What is that noise?

    Thanks to those who responded. I should have also included that the Pertronix EI I installed also included a new round coil, eliminated the old square can coil. But tractor does the same old coil or new coil. New coil delivers hotter spark. After reading your possible explanations, I do think it...
  3. G

    What is that noise?

    When I attempt to start my 9n, sometimes it let's out a sound I can only describe as a groan, (kind of like I do when I try to get off the couch, just kidding but not really). The starter engages and then sometimes it just makes a loud groaning noise for about 2 or 3 seconds, and I think the...
  4. G

    Question re: Pertronix Coil Location

    Well, I'm still trying to find out if it would be alright to mount the coil over by the battery or whether that location is too far from the distributer? The instructions that came with the Pertronix 1247xt kit said to mount the coil "upright", but I notice on some of the pics that were sent...
  5. G

    Question re: Pertronix Coil Location

    I want to thank all who have responded, and the pictures are a great help too. I now have a couple more questions. I find that the best location to mount the coil is close to and below the battery where I believe a tool box once lived. However, that location is beyond the reach of the coil to...
  6. G

    Question re: Pertronix Coil Location

    I have a 46 converted to 12 volt (neg. ground) 2N with a 3 wire alternator. I am rewiring whole tractor, also with new plugs and plug wires, and adding the Pertronix 1247xt kit that includes the round coil. Question is where do folks mount the round coil? For those who have switched over to the...
  7. G

    135 just quit while bushhogging

    Thanks to all for your responses. First thing this morning had to check it out and tractor started just fine and ran just fine, at least till I could get it back to the barn. Going to troubleshoot using the suggestions offered here. Might be a day or two, grandkids coming over. Priorities you...
  8. G

    135 just quit while bushhogging

    Ok. I let the motor get cold and still won't start, cranks fine but that's all. Doesn't seem like it's getting spark. I know the battery cables are all clean and tight, but I will check them again tomorrow. Any suggestions be appreciated. ol steve
  9. G

    135 just quit while bushhogging

    Hello all, newbie to this forum and hoping some of you knowledgable folks can help. I have a 135 Massey, 4 cyl. Continental gas engine, have had it for several years, always ran fine. The other day was bushhogging and motor started surging, kinda like I was running the throttle lever up and...
See more
Tractor Parts Tractor Manuals

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top