(800) 853-2651
SHOP NOW

Recent content by gpogpo

Yesterday's Tractor Forums
  1. G

    Farmall C--help with a carb part

    I have the original Marvel Schebler carb (TSX-319) on a Farmall C that needs a new needle/seat. I also have a Ford 134 ind. engine on a windrower that uses the same needle/seat. Can someone please tell me where to buy needle/seat sets for these engines--without buying a whole rebuild kit? If I...
  2. G

    Farmall hyd. pump?

    Couple more questions Mike: Is the M&W pump the same as the optional Farmall pump? Do you have any idea on the output flow of the pump?...(to run a small loader). Can the pump be installed on a late model H using the original cam gear? Was it fairly easy to get your H retimed with the new...
  3. G

    Farmall hyd. pump?

    Anyone know where I might find a cam gear hydraulic pump to fit an H? I'd like to power an older loader with hyd. bucket with it. (Do these pumps have enough output for that purpose?)
  4. G

    JD B crankshaft removal?

    I bought it several years ago. All the seller (long gone) told me was he thought it had magneto problems. It was running rough because the gear was loose and jumping back and forth.
  5. G

    JD B crankshaft removal?

    Thanks Mike. The gear was easy to get off since it was loose. Like you suspected it had a hairline crack. Almost missed it. Now I'm looking for a good used replacement. Sure hope it didn't mess up the crankshaft!
  6. G

    JD B crankshaft removal?

    Hey Mike, that's what I wanted to hear! Turns out all I had to remove to get to the crankshaft gear was remove the left bearing housing. The loose gear was right there. I'm going to clean up the surfaces, put in a new key, warm up the gear, add a little sleeve retainer and bang it back on...
  7. G

    JD B crankshaft removal?

    Oops.....I meant to say "without" removing the large right-side cover.
  8. G

    JD B crankshaft removal?

    Gotta get the crankshaft out of my B so I can press the gear back on. Anyone know if I can remove the crankshaft with removing the LARGE reduction gear cover from the right side of the tractor behind the clutch/pulley? I think I'd have to drain the transmission to do that?
  9. G

    John Deere B crankshaft gear install?

    Bob, Can you tell me if I can remove the crankshaft from a JD B without draining the crankcase and removing the large cover on the right side behind the clutch/pulley?
  10. G

    John Deere B crankshaft gear install?

    More good information! Thanks Bob!
  11. G

    John Deere B crankshaft gear install?

    Hey, good information Big! Never thought of using heat on the gear. I might be able to fix this thing without tearing the whole tractor apart! Thanks!
  12. G

    John Deere B crankshaft gear install?

    Anyone know about how much pressure it takes to press a John Deere B crankshaft gear (runs the cam gear) onto the crankshaft? If it turns out to be a little loose can I fix it? (Sorry, first msg I didn't check the email notification box)
  13. G

    John Deere B crankshaft gear install?

    Anyone know about how much pressure it takes to press a John Deere B crankshaft gear (runs the cam gear) onto the crankshaft? If it turns out to be a little loose can I fix it?
  14. G

    Need help--Case 430 wet tranny question

    Sure wish I could help but about all I can offer is a suggestion to keep asking on this forum. There is a fellow, John Parr, who owns a large heavy equip. salvage yard in Boise, ID. Trouble is I can't seem to come up with his website or email address. He is a semi-frequent participant on the...
  15. G

    Need help--Case 430 wet tranny question

    Thanks for the replys guys. I just took a close look at the 430.....It does have a wet hand clutch (no dry clutch--except for the main drive clutch of course). The lever is on the left side of the tranny housing. Can't see anything obviously wrong inside, but there is no pressure against the...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top