(800) 853-2651
SHOP NOW

Recent content by greentractorguy

Yesterday's Tractor Forums
  1. G

    CAT 3176 died and won't start

    Thank you for the replies. I went to the truck and used the hand primer and it got hard to push. I could hear the fuel returning to the tank even. There's about a half of a tank of fuel. The ECM was bad when I got the truck and the previous owners didn't want to spend the money to fix it. I have...
  2. G

    CAT 3176 died and won't start

    I have a Cat 3176 that was idling and warming up when it sputtered a bit and then came back up to idle for a second and then died and will not restart. The engine had a new ECM put on in December and was running normal until it died. The engine is in a 1990 White/GMC small semi truck. The engine...
  3. G

    Ford 876 fuel pump leak

    We have a Ford 876 with the Cummins L10 in it and there is a fuel leak coming from on the top of the pump. I was wondering if anyone has found a good diagram of the fuel system to look at. Thanks!
  4. G

    Radio speakers don't turn back on after key is shut off a...

    Thanks!
  5. G

    Radio speakers don't turn back on after key is shut off a...

    I bought and installed a new radio in a tractor and got everything hooked up and working. I shut the key off to do a few things and came back to try it out again. The radio powers on but the speakers won't come on unless I unhook both speaker wires and reconnect them. Any ideas would be great...
  6. G

    Looking for JD pedal tractor parts

    I have an old JD 130 pedal tractor that I would love to restore for my 3 year old daughter. Where is the best place to get parts for them? I need quite a few things to make it nice again. Thanks in advance!
  7. G

    Round baler size. 4x6 vs 5x6

    We are looking into buying a new baler with net this winter and can't decide on a JD 468 or a JD 568. The Deere dealer is the closest and pretty easy to work with. We've always had a 5ft baler but if it's easier to haul 4ft we might make the change. My main concern is for selling the bales if...
  8. G

    Christmas Tractor- lights.....

    I have done a few tractors pulling things, a swather and an old 49 chevy truck. Chasing lights make a huge difference and make things look great. I wish I could find the video of the swather. I had the lights on the header chasing so it looked like it was running. I can't seem to get the picture...
  9. G

    Keeping rodents from moving into your combine

    We use Bounce brand dryer sheets inside the cab and we tuck them in areas all around the combine. We had an old exterminator tell us it had to be Bounce brand. Ever since we started doing that we have had pretty good luck. And the cab always smells great.
  10. G

    Ford NAA 3 point won't lift

    Thanks guys. I went and tried all the suggestions so now it looks like my last option is to rebuild the pump. Are there any tricks or special ways to do things on these pumps?
  11. G

    Ford NAA 3 point won't lift

    I bought this NAA at an auction a few months ago not running. I now have it running good but the 3 point won't lift. I read up and tried blowing air in the dipstick cover with the top right plug out and it just blows back out when I take the air off. I also took out the top plug on the pump and...
  12. G

    8n not starting

    I just bought an 8n with a side mount distributor that wasn't running at the time I bought it. I put a new carb on it and still wouldn't fire. So I went ahead and gave it a full tune up. I put a coil, points and condenser(gap set to .025), cap and rotor on it. I had it running for a few minutes...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top