(800) 853-2651
SHOP NOW

Recent content by greg krush

Yesterday's Tractor Forums
  1. G

    PTO Overrun Clutch

    Any tractor with live power (live power means that there is a separate clutch for the PTO) does not need an overrun addition, the main clutch and the PTO clutch are not connected at all, when you disengage either one it will not effect the other. If your mechanic is used to 8N or other...
  2. G

    Oliver cables get hot

    have you pulled the PTO shaft?? pull that and then take the bolt out of the coupler where it attaches to the transmission, slide it forward and take it out, then nothing holding the engine in.
  3. G

    Add air-valve at bottom

    no problem adding air, it will bubble thru the liquid, just wash your air chuck good when you are done or it will corrode from the calcium.
  4. G

    Oliver 88 Steering Support

    move the upper piece to the other side, turn it around and it will hold the ball in place.
  5. G

    Value of Oliver 1650 setback wide front end

    Look down in the forum, there was someone who wanted an underslung front end for a 1655.
  6. G

    Oliver 77 Cracking Hydraulic Pump Center Plate

    I would guess that the centerplate that you put in also had a hairline crack but you could not see it, after you put some pressure on it when you started the tractor the crack opened up. If your parts tractor sat outside it most likely got water in it and cracked. I have have had some that...
  7. G

    1655 shifting and 3 point

    I have 2 1655s, One shifts better than the other, shifting can be difficult in over and under, but direct shifts well, R2 is opposite 4th for easy shifting, R2 might be a bit fast for manuvering around trees. Also be aware of freewheeling if working on hills.
  8. G

    mystery bolt?

    I probably have the bolts from an 1800 that ventilated the block, let me know if you cant find what you need.
  9. G

    Oliver 88 Row Crop won't go into either reverse

    Possibly broken rail but I would look at the detent balls that might be rusted, the balls and guides are in front of the transmission, more in the engine compartment, there are 3 rails under a cover if you do not have an endless belt pully or under the belt pulley drive if you have one. good...
  10. G

    Trying to figure out why starter won't engage

    have you checked the neutral switch? needs to be in neutral to start, these switches can go bad.
  11. G

    Looking at buying barn find Oliver 88, hydraulic valve question

    Pretty easy to change out the hydraulic unit, I would pull the unit anyway and check the center plate as most any tractor that has sat will have a cracked center plate. I pulled a 283 new holland baler with an 88 and it handled it just fine, would make it grunt in heavy hay but always came thru.
  12. G

    1800A air cleaner

    I have one off an 1800 B I am parting out if yours does not clean up
  13. G

    1850 Brake Actuator — buy new or used?

    I have them in an 1800B that I am parting out if you cant find one closer
  14. G

    1650 Holley Distributor

    I would check points, have seen them close up pretty quickly when new.
  15. G

    1850 Gasser won't start or backfires through the carb when it does.

    I would look for an air leak between the carb and cylinders, a small leak will make the carb not work properly, as you run the engine faster it will make the problem less severe, you can check for leaks with starting fluid and see if rpms change.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top