-
GGregorytractorguy replied to the thread Gleaner M2.I had my grandfather put the combine in gear and hold the brake for a few seconds. The belts and pulley are all spinning. Combine not...
-
GGregorytractorguy replied to the thread Gleaner M2.Thank you! Most likely will be running without them for now anyway
-
GIf need be, those heads will run without a spiral on the tip. It might hurt pulling corn in a little bit, but let’s say I really didn’t...
-
GGregorytractorguy replied to the thread Gleaner M2.Combine should be functional everything is working and adjusted according to book. Probably gonna need some fine tuning. But should be...
-
GThere's a period of time I'm missing. Or else a part of my brain that's missing! Certainly operating from old memories is hit and miss...
-
GI had a 1977 M-2 was a gear drive, most were hydro's but I believe till almost the end of the 2 series gear was an option.
-
GYou are right but what fun would that be.
-
GGregorytractorguy replied to the thread Gleaner M2.It does not have an idler pulley for traction drive. Belt is a little loose probably should get a new one eventually. Got a book on the...
-
GNot to disagree, cause I may be wrong, but aren't you talking about the header drive belt? I can't recall a idler on the gear drive...
-
GGregorytractorguy replied to the thread Gleaner M2.How do you look up old equipment on Agco website ? Agco only lets me look up newer equipment. Or anything made by Massey Ferguson.
-
GGregorytractorguy replied to the thread Gleaner M2.I bought the combine with 6 row corn head drove it home clean and greased and lubricated chains and shorten some. Only problem I have...
-
GGregorytractorguy replied to the thread Gleaner M2.It’s gear drive. floating tank filler with attached extension. I believe 130hp has side hill blower
-
GAn M2 is a good combine. That said, all machines break down and require high-dollar maintenance. If there was anyone in your area who...
-
GCan't go wrong with that one. I had an M3 for about 15 years, rolled almost 2000 hours on it with minimal downtime. Mine was a hydro...
-
GThat’s low hours if accurate. Unload auger can get weak coming out of the bin wear thin, as well as the ball bearings in the swivel...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy