(800) 853-2651
SHOP NOW

Recent content by guitarfule

Yesterday's Tractor Forums
  1. G

    TO 35 Hydraulic pump

    The toothed sleeve is on the front of the pump held with a cotter pin. There are no holes on the rear hydraulic pump shaft or front of the pto shaft. On there rear of the pump is the gear that slides/shifts for the pto to be coupled either neutral, with engine, and with rear end.
  2. G

    TO 35 Hydraulic pump

    Yes both pins holding the pump are in but not tight. As per the service manual says to install pto shaft and tighten pin last starting with the right hand side.
  3. G

    TO 35 Hydraulic pump

    I'm working on a TO 35. The hydraulic pump split. Went to install the new pump and put the pto shaft in and the pto shaft will not slide into the hydraulic pump needle bearing. The pto shaft is all the way into the housing but I come up about 1/4 away from the hydraulic pump shaft. I got...
  4. G

    White 145

    I have the engine and clutch housing removed. How is the over under fastened to frame or rear housing? The over under is junk and going to install a reman.
  5. G

    White 145

    Trying to pull and over under out of a 145 and having a hard time. Anyone do this before? Any help would be appreciated.
  6. G

    Case 630 Gas Throttle linkage

    Thank you! I ordered the spring will let you know if that works.
  7. G

    Case 630 Gas Throttle linkage

    I have a Case 630 gas and I'm having troubles figuring out how the throttle linkage on the right had side for the hand and foot throttle is supposed to go. Seems as if I'm missing some springs. The parts breakdown on case website is really no help. Any help would be appreciated. Thanks.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top