(800) 853-2651
SHOP NOW

Recent content by Harold Freyholtz

Yesterday's Tractor Forums
  1. T

    Help with MF no10 small sq baler please

    Hi Chaps, Was happily baling yesterday when the chain for the pick up drum broke, and then wrapped itself around the 2 other sprockets that drive the packer gearbox, and the plunger met the packer fingers and bent the packer arm and its all locked up. Question is. Can I remove the Packer...
  2. H

    1855 three point

    I have an old 1855 that I like to have the grandkids use to move bales with the 3 point. The tractor shifts so easy. The steering is fine and when we use a regular 3 point bale fork no problems. But I have one 3 point bale fork that lifts the bale 6 feet high and has a cylinder on the end so I...
  3. kcm.MN

    Thursday "Extra" Pic

  4. S

    Ford 2000. 3pt speed? Aux? Vent?

    What is this? It's on top of the rear end below the seat, where I'd normally expect the lift speed to be. Manual says speed adjust should be down on the side and the aux selector should be on top. This doesn't look the same though, no markings, spinning the sleeve does nothing. Is it just a...
  5. H

    Digital tach for 1086

    Where can I get a digital tach rebuilt for my 1086
  6. H

    986 1086

    What is the difference, turbo? If I used a 1086 would my fuel consumption be a lot more than a 986 where all the horses aren't needed? I noticed that 1086s are listed for less money generally than a 986, just wondering. Thanks
  7. H

    1070 970

    I know little about these tractors, never used one. But one neighbor has several 1070s. I see they seem to sell reasonably, $6000 to $7000. Another neighbor has one but he says he knows if the powershift goes out the tractor is toast due to the cost. Is this true? I need a backup tractor for the...
  8. H

    Rusty tools

    Where to you find these items? What store? Thanks
  9. H

    Rusty tools

    I have given to be a bunch of tools that are rusty including adjustable wrenches that no longer move. Any ideas on what to do? soak? or whatever?
  10. H

    Best tractor

    I am looking at a 986 IHC, 2-105 white, 4-85 white or a 1070 case. All about the same money. I run a grazing operation with a round baler and a 9 foot discbine. I have a 886 which will lug down in heavy hay on the discbine. Any advice, warnings etc. Thanks
  11. H

    1855 solenoid

    starter solenoid
  12. H

    445 seat

    Where can I get a seat and back rest for a 445 Moline? thanks
  13. H

    1855 solenoid

    I purchased a solenoid for my 1855 and at first glance it looked like a perfect match. When I finally got around to installing it I noticed that the solenoid should be rotated 90 degrees on its base. Is the a way to rotate the inner parts of the unit in relation to the outer part? I really don't...
  14. H

    cab heater

    I want to find a 12 volt cab heater for an older cab tractor that uses the radiator coolant, any ideas? thanks
  15. H

    602 cab wanted

    I tried to E mail you, did you get it? I am not good with this computer stuff.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top