Recent content by harry king

  1. H

    ford 650 chugging and dies

    ok. resistance is 135 on 12V coil and 140 on the 6V on the bench. Put 12V on tractor, key off, all wires hooked , still 135. Drained all gas and put in 94 octance from Exxon(same as all I guess). 87 degrees out, 53% humiditiy. All rest the same. Was going to check again and swap to 6V coil and...
  2. H

    ford 650 chugging and dies

    I have the other type of carb..the one with the hand screw on top front of carb. See my other reply from today.
  3. H

    more info on 650 Ford chugging

    additional info. I have also tried running a wire from battery to coil to eliminate switch and ballast. same problem. vapor lock with new 10% ehtanol fuel. I'm stumped.
  4. H

    ford 650 chugging and dies

    have a 650 ford. 12 volt system. ran fine last year. When it is cold , it will run for 30 minutes then start chugging and some times die while pulling a 6 foot finish mower..(like out of gas) Then it will only run for a few minutes and chug, with pto off and won't even pull tractor. idle is...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top