(800) 853-2651
SHOP NOW

Recent content by Hebrew62

Yesterday's Tractor Forums
  1. H

    Timing of Farmall M

    HI yes that The picture I posted today was when the mag impulse tripped. I starts about 2nd time turning over. Always starts easy even in the cold
  2. H

    Timing of Farmall M

    Hi I took the carb off my other M and cleaned it and this M runs ok with no Choke . The water is circulating in the radiator. Don't see any slippage on fan belt. It allows me to turn the engine part way and slips a little. I dont see any bubbles in the radiator just the water circulation. My...
  3. H

    Timing of Farmall M

  4. H

    Timing of Farmall M

    I am talking about daylight. I work during the day and is often dark when I get free and do not have a shop with lights, so I am working outside . I wish I had a nice shop but do not. I use the tractor to feed livestock, so do not always have time to work on it . There were several comments...
  5. H

    Timing of Farmall M

    Not ignoring your question, but figured that was easier to do in the light. Will do it today .
  6. H

    Timing of Farmall M

    Here is a picture of block
  7. H

    Timing of Farmall M

    I ran out of light but removed that block cover behind the carb and it was full clean antifreeze and not full of gunk. Clean around the sleeves and the port to water pump was clean. I started it before I took this off and didn't see any movement of water in radiator reservoir
  8. H

    Timing of Farmall M

    Hi , so there is a plate on both sides of the block, Do I need to remove both to clean the water jacket?
  9. H

    Timing of Farmall M

    ok, will turn it over by hand and see when the impulse fires and look at the pointer. Thank you
  10. H

    Timing of Farmall M

    Thank you
  11. H

    Timing of Farmall M

    Thank you. Will see if the water is moving if not them will remove that plate.
  12. H

    Timing of Farmall M

    not sure
  13. H

    Timing of Farmall M

    Thank you. I will remove the radiator cap and see if the water is flowing. I have another M that has a worn out cap that is lose and it never gets hot and can see the water moving in that radiator.
  14. H

    Timing of Farmall M

    Hi, yes, I used a piece of wire and made sure it was TDC on the compression stroke and the pointer was at the first of the two marks. I took the cap off the mag and the rotor was at the position of #1 plug wire. But again I have to have the mag tilted away from the engine as far as possible to...
  15. H

    Timing of Farmall M

    I was wondering the same
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top