(800) 853-2651
SHOP NOW

Recent content by Herbert Johnson

Yesterday's Tractor Forums
  1. H

    ford 8N carb

    How do I get to the 8N forum?
  2. H

    ford 8N carb

    The gas is dripping from a plug? at bottom center of card that looks like it has a hole in it.
  3. H

    ford 8N carb

    1952 Ford 8N carb is dripping gas from the bottom center of the carb. What to do?
  4. H

    Rear blade

    Just put a rear blade on my Ford 8N. What exactly do I need to buy to keep it from swaying back and forth? Thanks
  5. H

    sherman transmission

    Can't seem to shift my Sherman trans. one way or the other on my 53 Massey TO30. Tractor works fine otherwise using the normal 4 gears. Any ideas? thanks
  6. H

    PTO seal - Ferguson TE30

    Is it a big job to replace the seal where the PTO comes out at the rear of the tractor? Ferguson TE30.
  7. H

    ferguson to30

    Would like opinions on a Ferguson to30. I'm looking at one fully restored and need help making up my mind.
  8. H

    ferguson to30

    Would appreciate any opinions on a Ferguson to30 tractor. I have a chance to buy one fully restored and am trying to make up my mind. Thanks
  9. H

    OT New Toy coming

    None of the guns that you mention have Micro Groove rifling so you will be OK with what you are doing. Micro Groove is a different story alltogether.
  10. H

    OT New Toy coming

    If you have a Marlin .44 rifle with Micro Groove rifling it will not do its best with lead bullets. It will do its best with jacketed bullets. Any of the Marlins with the older Ballard rifling will do OK with lead. Commercial loaded ammo designated for a rifle will be jacketed bulletsl.
  11. H

    OT New Toy coming

    Your Marlin probably has "micro groove" rifling so make sure you use jacketed bullets. It will, otherwise, throw lead bullets all over the place.
  12. H

    reloading ammo ?

    I am 100% in faver of reloading but one thing I didn't see mentioned concerned carrying a concealed handgun. If you do make sure it is loaded with FACTORY ammo. If you have to use it a good lawyer will consider reloads as an INTENT by you to use it.
  13. H

    What was it like where you grew up?

    I grew up about 3 blocks from downtown Pontiac, Michigan. Spent as much time as I could at grandparents farm in Hadley, Mi about 40 miles north of Pontiac. I need to quit thinking about how thing used to be or I will go nuts. I spend a lot of time thinking about the period from 1945 until...
  14. H

    john deere mower

    Haven"t posted a dumb question lately to here goes; I installed the 60" mid mt mower today under my John Deere 770 compact diesel. Works OK but when I raise the mower one side comes up and the otherside doesn"t. Any ideas?
  15. H

    Squeaky brakes

    My 2011 vehicle with 13000 miles on it has very squeaky breaks for about the last week or so. Disc front and drum rear. Any suggestions before I go to the dealer. Thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top