(800) 853-2651
SHOP NOW

Recent content by HILL

Yesterday's Tractor Forums
  1. H

    Briggs & Stratton push mower no spark

    I have a Briggs series 450E mower that is not firing, disconnected the kill wire, checked the flywheel key, buffed the magnets and the contacts points on the coil, took my test light checked the spark plug wire to the laminated body of coil mot shorted out, reset the air gap, is this a good or...
  2. H

    John Deere H

    I have a flywheel with gear, starter and starter bracket for a model H. It came off a H that did not have the proper holes drilled correctly I changed it back to hand start. They are available.
  3. H

    Question for Wore Out on previous JD 755 compact

    The correct way to start a JD 755 compact tractor. You stated I could download the operated manual at the link belowbut the link does not show. Thanks Hill
  4. H

    John Deere 755 compact utility tractor (second listing)

    We went to look at the tractor again . We put a good battery in it to try to crank it sitting in the seat the stater did not engage. Turning the key to the left a light on the dash came on so I thank electricity was in the system. The brake pedal was locked light. The owner has died and I have...
  5. H

    JD 755 compact utility trator

    That what I was thanking , I did not get down on the ground and look under the mower. After getting home and looking at JD parts on line the power steering system looks thought to work on.
  6. H

    JD 755 compact utility trator

    I went with a friend to look at a John Deere 755 that he was thanking about getting. The tractor looked like it had not been run in quite awhile and while we was looking at it he started turning the steering wheel and turned with little restaurants and wheels not turning. We could turn it back...
  7. H

    John Deere model 50 fan belt

    The serial no. of the 50 models split at 5016058 and my tractor is above it, the belt for my tractor is B3288R. It is listed on JD parts look up on line. I used to be able to see the spec on line but I can not find that anymore.
  8. H

    John Deere model 50 fan belt

    My fan belt broke on my model 50 and this time I wonted to put the correct belt on it. About three years ago I had to put a new water pump on and I used a non JD belt. The belt is some where a little less than 41 inches to get it to work I had to shim up the generator to get it to operate right...
  9. H

    Rockshaft issues 1948 B

    The pto must be engaged and the clutch engaged also.
  10. H

    John Deer 180 46 inch cut

    I am working on putting a new blade belt on. Where can I find the correct way to thread the belt around the pulleys. The old belt only contacts about 25 percent of the main drive pulley which I know is not right. Thanks
  11. H

    pushrod tube dimensions

    This is the measurements of the PR tubes that came out of my 1945 model B about 20 years ago, steel. The LG 4.165, ID .640, OD small end .725, large end .730 . Here is how I made my PR tubes, I used 1/2 inch galvanized water pipe ( I would like to have used copper, brass, stainless steel but...
  12. H

    pushrod tube dimensions

    I made a pair of them a few years ago and the old ones are hanging on my shop wall. I will measure them tomorrow and post.
  13. H

    Shipping tractor weight

    Has anybody ever shipped a tractor weight about 150 lbs, what shipper did you use? Thanks
  14. H

    War survivors

    My father was a ww1 vet that was born in 1895 also.
  15. H

    JD #5 Pitman Available?

    . I failed to include my email. [email protected]. Thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top